Carlson Pet Products 0618 User manual

尺寸：２１０ｍｍ Ｘ １４８ｍｍ
印刷：书本式装订，黑白印刷
纸张：８０ｇ Ａ５铜版纸
版本日期：２０１２－０３－１３（第一版）
１４８ｍｍ
２１０ｍｍ
MODEL NO:
0618/0624/0632
READ ALL INSTRUCTIONS BEFORE ASSMBLY
AND USE OF GATE.
KEEP INSTRU CTIONS FOR FUTURE USE.
TUFFY EXPANDABLE GATE
with small pet door
Owner’s Manual
Carlson Pet Products,Inc
14305 Southcross Drive,Suite 105,
Burnsville, MN 55306
Phone:[phone]

(1)
Assembly and Installation Instructions
Please read these instructions carefully before installing your Tuffy
Expandable gate.
WARNING:
This Tuffy Expandable Gate is NOT to be used for Children.
This gate is to be used ONLY for Pets.
A loose or wobbly gate is not properly installed and therefore,
not ready for use.
Strangulation hazard- Pets can force themselves into very small
openings; use this gate with pets whose heads will not fit into
openings in the gate, between the gate and floor, or between the
gate and wall.
Install the locking mechanism on the side away from the pet.
Never use at top of stairs.
Check the gate regularly to see if all the hardware and mountings
are tightened.
Stop using gate if any parts become damaged or broken.
To prevent serious injury or death, securely install the gate and
use according to manufacturer’s instructions.
Contact Carlson for questions and replacement parts.
If in doubt about the use of your pet yard, call our customer care
line 952-435-1084.
Carlson Pet Products, Inc.14305 Southcross Drive, Suite 105,
Burnsville, MN 55306.
Made in China

(2)
INSTALLING YOUR EXPANDABLE GATE:
STEP 1: Start by placing your expandable gate in the opening that you
are closing off. The opening can be no smaller than 26” (66cm)
and no larger than 42” (106cm) wide.
STEP 2: With one hand on each side of the gate, simply pull each end of
the gate away from the center to expand it outward.
NOTE- When expanding the gate outward or when compressing the gate
inward, remember to always grab the outside frame of the gate,
NOT the inner round bars!
ATTENTION: If the opening you choose has molding near the floor, be
sure to move the gate up above the molding so that the
gate is installed on a vertically even surface.

STEP 4: Next, push down on the square locking pin on the top of the
adjustment mechanism. The pin will insert itself into one of the
holes in the middle horizontal bar. Doing this will secure the
adjstment mechanism in place.
(3)
STEP 3: Once the gate is touching both ends of the opening, pull up
on the square locking pin on the adjustment mechanism.
Then, while still holding the locking pin up, slide the entire
adjustment mechanism towards the center of the gate, until
it can go no further.
Lift
Slide

(4)
STEP 5: Finally, to tighten and secure the gate in place, turn the round
adjustment cylinder away from you (clockwise). This will create the
pressure you need to stabilize your gate and make it fit as securely as
possible. Turn the adjustment cylinder until the gate is tightly secured
in the opening and cannot easliy be pushed out.
Once the gate is secured in place, it is ready to use!
SMALL PET DOOR: To use the small pet door, pull back on spring pin to unlock for
opening and closing.
A
Door latch
Rotate away to tighten

(5)
TO REMOVE YOUR EXPANDABLE GATE:
STEP 1: Start by turning the adjustment cylinder towards you
(counter-clockwise). This will alleviate the pressure.
STEP 2: Lift up on the square locking pin and while doing that, slide
the entire adjustment mechanism away from the middle of the gate.
STEP 3: With both hand on the outer frame of the gate, slide the panels
inward and remove the gate from the opening.
CARE AND MAINTENANCE
1. Periodically check the gate for signs of damage, wear, or missing components.
2. Do not use if any parts are missing, worn, or are damaged.
3. Check the gate regularly to make sure all hardware and mountings are tight
and secure.
4. Do not use abrasive cleaners or bleach to clean your gate.
5. Clean your gate by sponging it with warm water and a mild detergent.
6. Wipe it dry immediately after cleaning.

Carlson Pet Products,Inc
14305 Southcross Drive,Suite 105,
Burnsville, MN 55306
Phone: [phone]