- 3 -
EN INSTRUCTION MANUAL INDUSTRIAL DISHWASHER
GENERAL INFORMATION
This dishwasher is in compliance with the provisions currently in force concerning safety. Improper use can cause damage to people
and / or property. Before starting the machine, read these instructions containing important information about installation and
safety. This manual is an integral part of the dishwasher and must be kept intact.
The dishwasher is only intended for professional use. It is designed for washing utensils (cups, plates, cups, bowls, trays, cutlery)
and in similar areas in the field of food and catering, and complies with international electrical and mechanical safety and EMC.
Personnel operating the machine must be regularly trained. Only trained personnel should use it. The dishwasher is not suitable for
use by minors and persons with reduced physical or sensory abilities, nor by people with psychological problems. The use of the
machine is permitted only to persons under the supervision of a responsible person. Do not allow children to play with the
dishwasher, there is the danger that they may become locked inside.
The manufacturer disclaims any liability for damage to persons or property caused by disregarding these instructions in the boo-
klet, or by incorrect use, and by interference with any part of the dishwasher. Replace any defective parts with new original parts.
This is the only way that the manufacturer guarantees the observance of safety standards and the correct operation of the machi- ne.
Do not use the dishwasher as a ladder, or to support people, objects or animals. Leaning or sitting on the open door could cause it
to tip over and endanger people. Close the door to prevent people tripping over it. Before installing this appliance, check that no
damage is visible. Never operate a damaged machine—it can be very dangerous.
The dishwasher must be installed and repaired only by authorised personnel. Work performed incorrectly can cause serious ha-
zards to the user, for which the manufacturer is not responsible.
The electrical safety of the machine is ensured only by a correct earth connection. It is very important to make sure that this
connection has been done correctly. If in doubt, have the system checked by a qualified technician. The manufacturer is not lia- ble
for any damages due to the absence of, or incorrect installation.
Observe the installation instructions contained in the installation manual. Prior to an electrical connection it is necessary to com-
pare the technical data, voltage and frequency shown on the machine nameplate, with the mains supply. The electrical supply must
match the machine demands, otherwise the machine could be damaged. If in doubt, have the system checked by a qualified electrician.
Do not connect the machine to the mains with extensions because there is insufficient electrical security.
To perform the installation work, or any maintenance or repair, disconnect the machine from the mains. The machine is connec- ted
to the mains unless the isolating switch is off.
Be careful when handling chemical products! These products, such as detergent and rinse aid, can be corrosive or irritant. Follow
the safety regulations on the packaging! Wear goggles and gloves! Carefully follow the safety instructions provided by manufac-
turers. Do not inhale powder detergent. Ingesting detergent can cause burns to the mouth and throat and lead to suffocation.
After any work done to the water supply, you must purge the water pipes to the dishwasher, or you risk damaging the water inlet
valve.
The machine and the surrounding area should not be sprayed directly with a jet of water.
Do not open the door when the machine is operating. There is a DANGER of splashing with hot water and detergent. If you open
the door at the end of the programme take care not to touch the heating elements located on the bottom of the tank (danger of burns).
