Celestion AN2075 User manual

!
!
!
Celestion AN2075 Replacement Speaker
Installation Guide
!
The kit should contain:
x1 Celestion AN2075 Speaker
x2 Connection Butts
!
1
Ensure PT01 is powered off and not connected to the mains. With the top cover closed, turn
over the PT01 and remove the 8 screws from the base. Gently lift the base up from one side
and locate both the USB Board and Mains In Board. Disconnect the ribbon plug and 2 cables
respectively.
2
Separate the two sections and prepare to remove the stock speaker.
3
Unscrew and lift the speaker from the base,
then cut the ‘red’ and ‘white’ speaker wires
with a pair of snips.

!
4
Screw the Celestion AN2075 speaker into position.
With plyers, crimp the end of the ‘red’ and ‘white’ speaker wires into the Connection Butt
base. Ensure there is a solid connection.
Gently crimp the open end of the Connection Butt to allow the Connection Butt to be
pushed Into the Speaker Post.
Ensure the ‘red’ speaker cable is pushed onto the ‘red’ marked Speaker Post and the ‘white’
speaker cable is pushed onto the other post.
Crimp both Connection Butts tightly to the Speaker Posts.
5
Fit the turntable back together by connecting the ribbon plug and 2 cables respectfully as per
Step 1.