Cenocco CC-9108 User manual

Technical Parameter:
Input: DC 5V
Charging Time: 2h
Made in P.R.C.
Precision Beard Trimmer
CC-9108
User Manual
Keep the appliance dry. Not to be used in bath or shower.
•This appliance is not intended for use by person (including
children) with reduced physical, sensory, or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
•Children should be supervised to ensure that they do not play
with the appliance.
•To prevent possible harm to the environment or human health
form uncontrolled waste disposal, such as the unused batteries
and motors. etc. Recycle them responsibly to promote the
sustainable reuse of materials resources.
•To return your used device, place use the return and collection
systems or contact the retailer where the product was
purchased. They can take this product for environmentally safe
recycling.
•Cleaning the housing using only a cloth slightly dampened water
or a mild soap solution.
•Never use a caustic solution.
•Never submerge the clipper in water.
•Keep away from the children.
•This clipper may become warm during operating and/or
charging, this is normal.
•When using, do not hold the power soft line, to prevent possible
harm and to avoid accidents.
•Never tamper with moving parts.
•Be sure to charge one time at least within one year after
purchase
WARNING:
CAUTION:

•Charge the appliance fully before you use it for the first
time or after a long period of disuse.
•Do not charge if the temperature is lower than 0° or
higher than 40°C.
•The standard charging time is 2 hours,
•When it is fully charged, the appliance has a cordless
operating time of up to 240 minutes.
•During charging the indicator light shows red.
•Push the switch button to ON, then it can be used.
1. Beard Trimmer
5. Protection Cap
2. Comb (1mm)
6. Cleaning Brush
3. Comb (2mm)
7. USB Charger
4. Comb (3mm)
8. Oil Bottle
•The clipper operates or corded.
•Put the adaptor connected with the jack of the battery
pack which lies at the bottom of the machine, then put
the adaptor pins connected with the power.
1. When load and unload the comb attachment, please ensure
the power switch is at OFF position. Attached comb of 1,2 and
3mm combs for different cutting length (Fig. 11).
2. Push the comb button as (Fig. 12) you can change the comb
with other size.
*Use the brush, to clean the blades to remove hair which may
be caught between the blades.
Remove the comb and clean it with the brush or rinse it under
the tap (Fig 14)
CHARGING:
PARTS IDENTIFICATION:
HOW TO USE:
HOW TO USE THE COMB
ATTACHMENT:
MAINTENANCE OF THE BLADES:
CLEANING UNDER THE TAP: