Chamberlain B/W User manual

#
#
#
1
2 3
4 5 6
7 8 9
0
*
##
?
#
INSTALLATION FOR EL2000
CAMERA MODULE MODELS EL2000BWCAMKT,
EL2000CCAMKT AND EL2000DVRCAMKT
BLACK/WHITE, COLOR
& LOW LUX COLOR
CAMERA MODULES
FOR THE EL25 & EL2000 TELEPHONE
ENTRY ACCESS CONTROL SYSTEMS
#
#
1
2 3
?
4 5 6
7 8 9
*
0 ##
#
#
#
#
#
1
23
?
456
789
*
0#
#
#
#
#
#
23
1 Disconnect power to the unit.
2 To open, apply pressure to the right-side of the unit.
3 While maintaining pressure, turn the key clockwise.
4 Open the cover.
5 To remove the LED board, unplug the wire harness from LED
board and remove the screws (3). Do not remove the rubber
O-ring.
6 Replace black plastic lens with the clear lens. Keep rubber
O-ring in place.
7 Install the camera module. Reconnect the LED board wire
harness to the camera module.
8 Feed a coaxial cable (not provided) through the conduit hole
in the back mounting plate of the unit. Connect a BNC coaxial
connector to the back of the camera module.
9 Close and lock the unit.
10 Reconnect power to the unit.
NOTE: If the EL2000 is connected to a home entertainment system,
the home entertainment system must be switched to video input.
4
5
7
8
6Clear Plastic Lens
Camera Module
Wire Harness
LED Board
O-ring
BNC Coaxial Connector
A static discharge can damage circuit boards.

LED
LED
Board
Board
Call
Call
Button
Button
Board
Board
+
Call Button
Board
© 2011, The Chamberlain Group, Inc.
114A2972E All Rights Reserved
INSTALLATION FOR EL25
CAMERA MODULE MODELS EL25BWCAMKT,
EL25CCAMKT, AND EL25DVRCAMKT
1 Disconnect power to the unit.
2 Unlock and open the unit.
3 To remove the LED board, unplug the wire harness from LED
board and remove the screws (3). Do not remove the rubber
O-ring.
4 Replace black plastic lens with the clear lens. Keep rubber
O-ring in place.
5 Install the camera module. Reconnect the LED board wire
harness to the camera module.
6 Feed a coaxial cable (not provided) through the conduit hole
in the back mounting plate of the unit. Connect a BNC coaxial
connector to the back of the camera module.
7 Close and lock the unit.
8 Reconnect power to the unit.
3
4
56
LED
Board
Call Button
Board
+
+
H2 100A UD H2 100A UD
H2 100A UD H2 100A UD
Wire Harness
Clear Plastic Lens
O-ring
Camera Module
Coaxial Cable
BNC Coaxial Connector
NOTE: If the EL25 is connected to a home entertainment system,
the home entertainment system must be switched to video input.
FOR VERTICALLY MOUNTED EL25 UNITS
The camera lens board must be repositioned 90 degrees
counterclockwise before the above steps can be performed.
When repositioning the camera board carefully remove and set
aside the 2 mounting screws.
“Portrait” positioning for vertical mounting
Rotated 90°
A static discharge can damage circuit boards.