Cherryman ZET110 User manual

Warning
2. Do not use this chair unless all screws are securely tightened.
3. Check that all screws are tightened every six months or as needed.
4.
5. Do not use this chair as a stepladder.
1 2 3
4
Seat /Back Assembly
Tighten Back Frame to the Seat
using Short
Bolt (K), Lock Washer (L) and Flat Washer (M ).
F
Hx5
1/2
G
Assembly Instructions
ZET110 task chair
Item Part Name Part # Qty
A Back Frame Black/White
B
C Right Arm Black/White
D Seat Frame Black/White
E Seat Mechanism
F Gas Cylinder G00340
G Base Black/White
H Caster 5
I 4
J
Medium M6x25
6
K 3
L Lock Washer M8 3
M Flat Washer M8 3
N Hex Wrench 5mm 1
Seat Mechanism Assembly
Using Medium Bolts(I) screw the
Seat Mechanism(E) to the under-
side of the Seat Frame(D).
Base Assembly
Firmly snap Casters (H) into
Base (G).Place base on ground
with casters attached. Drop Gas
Cylinder (F) into base with narrow
end pointing up.
Arm Assembly
Using Long Bolts(J) screw the
Arm(B,C)to the underside of the
Seat Frame(D).
E
5
Final Assembly
With the Base on the ground,
carefullly align the Gas Cylinder with
the hole in the center of the underside of the
Seat Mechanism, applying pressure.
For assistance, call [phone] or visit www. cherrymanindustries.com
Mechanism
Mechanism
A
D
E
F
G
B
C
H
I
E
Ix4
D
CB
Jx3
Jx3
J
A
Kx3
K
M
L
Long Bolt M6x35
Short Bolt M8x20
1. This product is for single person use only.
4. Dispose of all packing materials properly. Do not place the plastic cover over the
G00356/G00357
G00354/G00355 1
1
G00352/G00353 1
1
1
G00342
G00336
G00337
G00361
G00362
G00363
G00339
G00341/G00351
G00358/G00359
G00360
1
1

1 2 3
4 5 6
Slip Cover Assembly Instructions (Optional)
ZET110 task chair
Uninstall the seat shell by removing
the screws with a philips screwdriver.
Unzip the seat cover. Remove the cushion.
Put the cushion in the
new seat cover.
Align the new cover with the holes
and zip up the new seat cover.
Install the seat shell by installing the
screws with a philips screwdriver.
2/2