Cherryman ATT106 User manual

Warning
1.
2. Do not use this chair unless all screws are securely tightened.
3. Check all screws are tightened every six months or as needed.
4.
5. Do not use this chair as a stepladder.
1 2 3
4
F
Hx5
1/2
A
D
E
F
G
B
C
G
H
B
J
Jx3
D
C
A
Kx3,Lx3,Mx 3
M
L
K
Jx3
Assembly Instructions
ATT106 Atto task chair
Item Part Name Part # Qty
A Back Frame Black/White G00328 /G00329 1
B Le Arm Black/White G00330/G00331 1
C Right Arm Black/White G00332/G00333 1
D Seat Frame Black/White G00349/G00350 1
E Seat Mechanism G00334 1
F Gas Cylinder G00340 1
G Base Black/White G00341/G00351 1
H Caster G00342 5
I Short Bolt M6x25 G00336 4
J Medium M6x35 G00337 6
K Long Bolt M8x50 G00338 3
L Lock Washer M8 G00309 3
M Flat Washer M8 G00310 3
N Hex Wrench 5mm G00339 1
Seat Mechanism Assembly
Using Short Bolts(I) screw the
Seat Mechanism(E) to the under-
side of the Seat Frame(D).
Base Assembly
Firmly snap Casters (H) into
Base (G).Place base on ground
with casters attached. Drop Gas
Cylinder (F) into base with narrow
end pointing up.
Arm Assembly
Using Medium Bolts(J) screw
the Arm(B,C)to the underside of
the Seat Frame(D).
E
5
Final Assembly
With the Base on the ground,
carefullly align the Gas Cylinder with
the hole in the center of the underside of the
Seat Mechanism, applying pressure.
For assistance, call [phone] or visit www. cherrymanindustries.com
Seat /Back Assembly
Tighten Back Frame to the Seat using Long
Bolt (K), Lock Washer (L) and Flat Washer (M ).
E
Mechanism
Mechanism
I
EIx4
D

123
4 5 6
Slip Cover Assembly Instructions (Optional)
ATT106 Atto task chair
Uninstall the seat shell by removing
the screws with a philips screwdriver.
Unzip the seat cover. Remove the cushion.
Put the new seat cover on
the cushion.
Align with the holes and zip
the new seat cover.
Install the seat shell by installing the
screws with a philips screwdriver.
2
/2