CHIEF FPM SERIES User manual

8803-000034 Rev. B 05/05
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: [phone], Email: [email protected]
INSTALLATION INSTRUCTIONS
FPM SERIES
SMALL FLAT PANEL DISPLAY
PITCH-ADJUSTABLE WALL MOUNT
Exclusive Q2™ Mounting System
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
(1) FPM Wall Bracket (4) Drywall Anchor
(2) Wood Screw (2) Washer, Flat, .25 ID X .56 OD
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
Flat Panel Displays are Extremely Fragile.
If Monitor Uses a Screw Size Other Than M4 X 10mm (M4 X 20mm),
DO NOT USE M4 Screws Provided. Monitor Damage Could Occur.
Interface Bracket Installation:
1. See installation procedures accompanying your mounting bracket.
Optional Latching Flag Placement:
1. Remove Phillips head screw, Nylock nut and latching flag (see Figure 2).
2. Reposition latching flag and secure using Phillips head screw, Nylock nut.
CAUTION!
Figure 1
Remove screw
and nut Move latch
Figure 2

Drywall Installation Procedures:
Minimum Sheetrock Thickness ½ Inch.
2. Using the wall bracket as a template at the desired mounting location, mark the location of the four
outer mounting holes.
3. Using a 3/8-inch drill, drill four pilot holes
to a minimum depth of 1 1/2” at the locations marked
in Step 2.
4. Install an anchor bolt in one of the pilot holes and tighten anchor bolt until it is fully seated (see
Figure 3).
5. Remove and retain bolt and washer from anchor and repeat Step 4 and 5 for three remaining anchor
bolts.
6. Using four bolts, with washers installed, secure wall bracket to wall.
Wood Stud Installation Procedures:
1. Locate stud and, using wall bracket as a template at the desired height, mark the location of the two
center mounting holes.
2. Install a .25 ID x .06 OD flat washer on each of the two wood screws.
3. Using the two wood screws with flat washers installed, secure wall bracket to wall.
Mounting Display with Interface Bracket to Wall Bracket:
1. Make sure the latching flag on the mounting bracket is in the unlocked position (see Figure 4).
2. Place your small flat panel display; with interface bracket attached, onto the wall bracket, making
sure it is securely seated.
3. Lower the latching flag on the wall bracket, locking small flat panel display in place (see Figure 5).
Figure 5
C
A
U
TI
ON!
Outer Mountin
g
Holes
Figure 4
Locke
d
Unlocke
d
%%c0.375
(
PREDRILL HOLE
)
INSERT ANC HO R INTOPPREDRILLED HOLE
CW
A
NCHOR BARBP
(
STOPSANCHORROTATION
)
#10-24 Screw Ancho
r
O 0.375
(
Predrill Hole
)
Insert anchor into
predrilled hole Anchor Barb
(Stops anchor rotation)
Turn 10-24 screw clockwise
until anchor fully seats
against back side of wall
CW
Figure 3
Inner Mountin
g
Holes