1
A
{@}
\=Y 8,,*,l))
Setup
play audio from a BT device, you need to
ir.the device with the speaker. you can pair up
eight devices.
On your BT device, turn on BT and scan for
ces in its BT menu.
ready to play music.
.lf pairing times out(the BT status light stops
ing red and blue),press and hold tn6 pair '
Phone button until the BT status light blinks red
blue again. Repeat step 3.
additional BT devices
and hold the Pair or: phone button unill the
lT status light blinks red and blue. Repeat steps
and 3 above.
C Operation
On your NFC device,turn on NFC.
Turn on the speaker.when the Status lndicator
s red and blue, put your NFC device near the
lo^cation on.the speaker(NFC on the right side).
The Status lndicator turns solid blue aftei conn
t"/r€/
tt
u:
Turn on the speaker. When powering up for the
'st time, the speaker is discoverable foi 2 mi
s and is ready for pairing. The status indicator
s red and blue.
When"the speaker" appears on the device list of
rur BT device, selecl the',speaker',.(lf a pass code
requeste-d, enter 0000.) The BT staius light turns
id blue after pairing is established. The jpeaker
, the speaker is ready to play music.
--@^@-
l<) -
Charging
About once a month, fully charge
the speaker(about 4 hours).
1. Plug the charging cable into the
speaker's charging port and power
adapter.
2. Plug the adapter into an AC ouilet.
Note: You can also use a computer
(with the power) for charging.
Plug the charging cabte into the USB
port.
Status indicator:
Solid red=Charging
Black=Fully charged
Blinking red=Very low battery
Battery saving
The speaker enters power saving mode
if no audio is played for 30 minutEs..
Slide the power switch olf and then on
to wake the speaker.
'@;'e
Troubleshooting
The speaker doesn't work or it won't pair.
. Try moving your device closer.
. ls the speakerturned on and charged?
- Turn the speaker off and then on to wake it
. ls BT enabled on your device or computer?
. Try repeating the setup procedure in this
guide or pair with a different BT device.
. The speaker plays music from one device
at a-time,unpair the device not being used.
(Refer to your devicedocumentation for help.)
Pair a new device using the setup proceduie.
. lf pairing with a computer, specify the
speaker as the audio out device on the
computer.
