© Clare Controls, LLC. 1 / 2 Doc ID – 1297 • REV 03
CLIQ.RACK Kit Installation Sheet
Last modified: 09/29/16
Description
The ClareHome CLIQ.RACK provides an adjustable shelf for
up to 4 CLIQ devices. Use the CLIQ.RACK when connecting
multiple CLIQ devices in a structured equipment rack. The
CLIQ.RACK tray slides into the equipment rack and is secured
by 2 screws on each side. The rack features 2 built in
connectors to attach the CLIQ.host and CLIQ.connect.
Unpacking the CLIQ.RACK
Remove all contents from the CLIQ.RACK packaging and
ensure you have the following items.
1 × CLIQ.RACK tray (p/n 200-1785-4)
WARNING: Hazard of electrical shock. Exercise extreme
caution to avoid physical contact with bare connectors and
terminals.
Installation
The CLIQ.RACK is designed to slide into an equipment rack. It
acts as a tray for up to 4 CLIQ devices, keep this in mind for
installation placement.
To mount the CLIQ.host to the CLIQ.RACK:
1. Remove the base connecter cover from the bottom of the
CLIQ.host.
2. Align the bottom of the CLIQ over either of the connectors
on the tray.
3. Press the CLIQ onto the connector, the magnets in the
CLIQ secure it in place.
To mount the CLIQ.connect to the CLIQ.RACK:
1. Remove the base connecter cover from the bottom of the
CLIQ.connect.
2. Align the bottom of the CLIQ.connect over an available
connector on the tray.
–or –
Remove the cloud cover on the top of the CLIQ.host or
CLIQ.connect already connected to the RACK, and then
align the CLIQ.connect over the other device’s connector.
3. Press the CLIQ.connect onto the connector, the magnets
in the CLIQ.connect secure it in place.
To install the CLIQ.RACK tray in an equipment rack:
1. Slide the CLIQ.RACK tray into the equipment rack, and
then hold the CLIQ.RACK tray in the desired position.
2. Place a screw in the bottom-right mounting hole of the
tray, and then tighten the screw.
3. Place a screw in the bottom-left mounting hole, and then
tighten the screw.
4. Repeat steps 3 and 4 using the top-mounting holes.
Figure 1: CLIQ.RACK tray ear attached to equipment rack
Figure 2: CLIQ.RACK tray with a CLIQ.host and CLIQ.connect in
an equipment rack
