Clark Synthesis TACTILE SOUND TA0.1 User manual

www.clarksynthesis.com
6/2008 Ver. 1 ©2008 Clark Synthesis, Inc.
OEM Installation Guide
TA0.1 Amplifier with Wired Remote
!
NOTE: It is very important that the amplier and the
Remote Control be installed in such a way that either
unit can be removed should servicing or replacement be
required.
For additional questions/concerns/issues, contact
Clark Synthesis or visit our web site.
Clark Synthesis, Inc.
8020 Southpark Circle, Suite 600
Littleton, CO 80120
Phone: [phone]
Fax: [phone]
Web: www.clarksynthesis.com
Email: [email protected]

www.clarksynthesis.com
TA0.1 AMPLIFIER- OEM INSTALL TA0.1 AMPLIFIER- OEM INSTALL
The TA0.1 can be custom mounted for use in a variety of applications.
By utilizing the pre-drilled holes in the mounting plate and the Remote
Control, the installer can mount the amplier to almost any surface
that provides 1) access to the Remote Control, 2) access to the
Input/Output Panel and the AC Panel, 3) adequate ventilation for the
amplier, and 4) the ability to remove the amplier or the Remote
Control for servicing should that become necessary.
CAUTION: Insure there are two (2) inches of clearance
around the amplier. DO NOT block the air vents. The
amplier will overheat if it does not have adequate ventilation.
The following steps describe the process for mounting the TA0.1
amplier:
Determine where you want to mount/place the Remote Control.1.
Determine where you want to mount/place the amplier.2.
Holding the Remote Control in the position you determined in 3.
#1, extend the wire from the Remote Control to the amplier’s
prospective location to determine if it can reach the amplier
without being overstretched or pinched in any way. If the wire
cannot reach, or will be overstretched/pinched, adjustments will
need to be made to the mounting location(s).
Once an adequate location for the Remote Control and the 4.
amplier is found, attach the remote control using the pre-drilled
holes in the corners of the box (see below). To avoid damaging
the box, use 5/8 inch or M8 at washers.
!
Attach the amplier to the mounting surface using the holes in 5.
the mounting plate (see below).
Connect the wire from the Remote Control to the amplier.6.
!
!
CAUTION: When mounting in furniture, it is important to
insure the wires going to and from the amplier, including
the wire from the Remote Control, will not be pinched or cut
by hardware moving within the chair, e.g., footrest arms,
recliner assemblies, etc.
NOTE: It is very important that the amplier and the
Remote Control be installed in such a way that either
unit can be removed should servicing or replacement be
required.