Thank you for purchasing this
CLARKE
spotting
scope.
Your new Scope is manufactured to a very high
standard, if used as directed will ensure you
achieve many years of trouble free use.
Please read these instructions carefully before
using your scope.
SAFETY PRECAUTIONS
NEVER
look directly at the sun with scope, as by
doing so could lead to permanent loss of vision.
NEVER
place the scope in a position where the
sun can be directed through the lenses, Fire
may result as a consequence.
Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice.
Assembling the Scope Instructions For Use
A-
bjective Lens.
B-
Scope Body.
C-
Focusing Ring.
D-
Zoom Ring.
E-
Eyepiece with roll up cap.
F-
Pan Lever .
G-
Tripod.
H-
Scope Securing Screw.
Specifications
Magnification O jective Lens Dia Prism Type Weight Length Field Of View (Width)
15X to 45X 50mm Roof Prism 1.2Kg 530mm 15X = 54m@1000m
45X = 18m@1000m
TAKING CARE OF YOUR SPOTTING SCOPE
Remove any dust from the lenses with a blower and/or a soft lens brush which can be purchased
from any camera shop. The lenses can be cleaned using approved lens cleaning solution and a
soft lens cloth.
The body can be wiped over with a soft damp cloth,
DO NOT
use any chemicals or abrasive cleaners.
When the scope is not to be used for long periods, store it in a well ventilated location, avoiding
high temperatures and humidity.
Avoid strong impacts caused by bumping or dropping the scope.
DO NOT
apply excessive force when using the scope.
Spotting Scope Part No 4499200
Ideal for nature and bird watching, features a powerful zoom, focus control and large objective lens
with blue anti-glare coating. Soft rubber eyepiece for viewing comfort, also can be rolled back for
users wearing glasses. Complete with metal tripod and carry case.
A
BC
D
E
F
G
H
Before the scope is used it must be assembled
first, the scope and tripod are stored in the carry
case and should always be disassembled and
returned to the case when finished spotting.
Stand the tripod on a flat level surface, ensure
all three legs are fully open.
Position the scope onto the tripod, lining up the
securing screw (H) with the threaded hole in the
block attached to the scope body.
Before tightening the securing screw (finger tight
only), ensure the block is in line with the tripod
support platform, tighten securing screw (finger
tight only).
Stand the assembled scope on a surface
capable of supporting all three tripod feet.
Ensure all three legs are open fully, and ensure
the scope cannot fall over, as this could
damage it.
Loosen the pan lever (F) by turning the handle
anticlockwise, aim the scope at the desired
subject.
Using either eye look through the eyepiece whilst
closing the other eye and locate the subject
using the pan lever.
When you are able to see the subject in the
centre of the lens, gently lock the pan lever by
turning the handle clockwise,
(DO NOT
OVERTIGHTEN).
Adjust the focus ring until the optimum view is
obtained.
Now adjust the zoom ring to the desired
magnification, sometimes it may be necessary
after adjusting the zoom to re-focus slightly using
the focus ring again.
