
WARNING
Make sure that your field of view is not
obscured after mounting your Golf Car
Organizer to your golf car.
CAUTION
Be sure your organizer is strapped securely and
tightly to your golf car.
CAUTION
Although your organizer is treated to resist and
repel water, no fabric is completely waterproof.
Wrap any items that can be damaged by heavy
rain in plastic.
Installationontoagolfcar
Your organizer attaches to the inside of your golf car on
the roof support posts just under the roof line.
IfyouareattachingyourorganizertoaClubCar®golf
caryouwillneedtouseanadaptorbarwhichissold
separately.Pleaseseethenextsection;“Installation
ontoClubCars®.”
Wrap the four
web straps
found at
either end of
the organizer
around the roof
support bars
(Fig. 1). Thread
the end of each
strap through
the buckles,
running the
strap through
the buckle
threading path
(Fig. 2).
Secure loose
strap ends into
the provided
strap keepers.
Fold or roll any loose web straps over upon themselves
to form a 2-3 inch length end then slip the folded web
strap into the open hook to secure your straps.
Notethatthesixstrapslocatedinsidethemain
centerpocketareneededonlyifyouareinstalling
yourorganizerontoaClubCar®golfcar.Ifyouare
notinstallingyourorganizeronaClubCar®theseare
unecessary.
InstallationontoaClubCar®golfcar
Before tting your Fairway Golf Car Organizer to a Club
Car® golf car an adapter bar (sold separately) must rst
be installed.
Adapter bar assembly
Slip the two pieces of your adapter into each other to
form a ‘U’ shape as shown (Fig. 3).
The adapter bolts to the rear roof posts of your golf
car using two U-bolts. Locate the two
U-bolts from the parts bag. Place the
adapter on the top and inside of the rear
roof posts of your golf car as shown
(Fig. 3). Insert a U-bolt over each roof
post and through the holes in
the adapter.
Adjust the adapter so that it is level and the top of
both ends of the bar are just below the roof line. Add a
washer on each end of the U-bolt, then a lock washer,
then a nut then tighten all nuts with a wrench (Fig. 4).
Attaching your organizer to the adapter bar
Detach the four buckle straps that are connected to your
organizer. Your organizer comes with two short straps
with buckles on either end and four rip-and-grip close
straps that are used to
attach it to the adaptor
bar. You can nd these
straps inside the main
center pocket.
Locate the two straps
with buckles on either
end. These straps
attach to the D-rings on the top corners of the back of
your organizer (Fig. 5). Attach the end of the strap to the
D-ring on the organizer by turning one of the end buckles
and passing the short end through the D-ring. Rotate the
buckle to keep it from slipping back through the D-ring.
Instructions: Fairway Golf Car Organizer
(Fig. 2)
(Fig. 1)
(Fig. 3)
(Fig. 4)
(Fig. 5)