Clear One LS5WT User manual

ClearOne LS5WT Wall Mount Speaker
INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS
ClearOne LS5WT Wall Mount Speaker
Tools Required
Pencil, Hammer, Three (3) Screws, Anchors (if mounting to drywall),
Small Phillips Screw Driver and a Drill
Determine where the speaker is to be mounted and whether it is to1.
be mounted vertically or horizontally.
Unscrew the Fastener thumbscrews on either sides of the speaker2.
to remove the U-bracket.
Using the U-bracket as a template, mark the three holes in the wall3.
with a pencil.
Drill the appropriate size holes for the screws or anchors as4.
necessary depending on the mounting surface being used (wood,
drywall, etc.)
If mounting in drywall, use the hammer and carefully tap an anchor5.
into each of the drilled holes.
Line the U-bracket up with the holes and screw it in place.6.
Adjust the Wattage Tap on7.
the back of the speaker
for the 8Ω (“THRU”) or the
appropriate 100V or 70V
position.
Carefully remove about8.
3/8” of insulation from the
ends of the speaker wires.
Loosen the two speaker9.
wire input post screws on
the back of the speaker.
Wrap the positive (usually10.
white-striped) wire around
the positive (red) Input
Post Screw and carefully
tighten securely.
Repeat for the negative 11.
(usually clear) speaker
wire, wrapping it around
the negative (silver) Input
Post Screw and carefully
tighten it to secure in
place.
Position the speaker so the12.
speaker mounting holes line
up with the two U-bracket
fastener holes.
Insert each of the thumbscrew13.
fasteners through the bracket
mounting holes and tighten to
secure speaker to U-bracket.
CAUTION: Do not over-tighten the screws.
SPECIFICATIONS
Acoustic and Electrical
Speaker Type 2-Way, ClearOne Wall Mount Speaker (Part # 910-151-002-01)
Frequency Range 80 Hz to 19 kHz
Power Handling 30 Watts RMS 80 Watts PEAK
Nominal Sensitivity 90 dB SPL, 1W @ 1m
Nominal Coverage Angle 110° Conical Coverage
Nominal Impedance 8 Ohms
Transformer Taps
70V: 1.25W, 2.5W, 5W, 7.5W, 15W
100V: 2.5W, 5W, 10W, 15W, OFF
THRU: 8Ω
Woofer 5” (127 mm) Polypropylene Cone with Moisture Resistant Rubber Coating
Tweeter 0.5” (12.7 mm) Mylar Tweeter
Termination Two (2) Input Termination Screws (Red = Positive Post, Silver = Negative Post)
General
Dimensions (H x W x D) 11.26” x 8.27” x 7.48” (286mm x 210mm x 190mm)
Net Weight (ea) 5 lbs (2.27 kg)
NOTE: All nominal levels are at ±10%.
NOTE: Specifications are subject to change without notice.
© 2010 ClearOne Communications, Inc. All rights reserved. Information in this document is subject to change without notice.
Other product names may be registered trademarks of their respecitve owners who do not necessarily endorse ClearOne or ClearOne’s products in the United States and/or other countries.
ClearOne Document: 800-151-001 Rev 1.0 June 2010