Clear One LS6CT User manual

ClearOne LS6CT Ceiling Speaker
InstallatIon InstructIons

© 2009 ClearOne Communications, Inc. All rights reserved. Information in this document is subject to change without notice. Other prod-
uct names may be registered trademarks of their respective owners who do not necessarily endorse ClearOne or ClearOne’s products in
the United States and/or other countries. C learOne Document: 800-151-000 Revision 1.5 July 2009.
INSTALLATION INSTRUCTIONS
ClearOne Ceiling Speaker
1. Take the cutout template from the packaging
box and punch out along the larger perforated
circle. Place the cutout template against the
bottom of the ceiling and trace the inside.
Carefully cut out the ceiling material along the
circle.
2. Remove the top cover to access the speaker
wires. Use wire nuts to connect the speaker
wires connecting the positive signal to the red
wire and the negative signal to the black wire.
Install the conduit and secure the con-
nections.
3. Loosen the four screws on the front baffle
(counter clockwise) a 1/2 turn. Tighten the
screws (clockwise) until the dog legs clamp
the speaker to the ceiling.
CAUTION: Do not over tighten screws.
4. Connect a secondary support line from the
seismic tab to a secure support point. Set the
rotary tap selector and install the speaker
grille.

© 2009 ClearOne Communications, Inc. All rights reserved. Information in this document is subject to change without notice. Other prod-
uct names may be registered trademarks of their respective owners who do not necessarily endorse ClearOne or ClearOne’s products in
the United States and/or other countries. C learOne Document: 800-151-000 Revision 1.5 July 2009.
Specifications:
Acoustic and Electrical
Speaker type 2-way, ceiling speaker with
metal back can
Frequency range 65 Hz to 20 kHz,
Power handling 60 Watts RMS
120 Watts PEAK
Nominal sensitivity 88 dB, 1W@1m
Nominal coverage
angle 110° conical coverage
Nominal impedance 8 ohms
Transformer taps
70V:: 30W, 15W, 7.5W,
3.8W, 1.9W, 8 ohms 100:
null, 30W, 15W, 7.5W, 3.8W,
8 ohms
Woofer
6.5" (165 mm) poly-
propylene cone with mois-
ture resistant coating
Tweeter 3/4" (19 mm) silk dome
Overload protection
Full range power limiter with
the 8 ohm direct input only,
protecting the tweeter,
woofer, and crossover.
General
Temperature/Humidity
Storage: -40 to +158 °F (-40
to +70 °C) / 10% to 90%,
noncondensing Operating:
+32 to +122 °F (0 to +50
°C) / 10% to 90%, non-
condensing
Listings UL1480
Compliances CE
NOTE: All nominal levels are at ±10%.
NOTE: Specifications are subject to change without
notice.