Coalesse X-Stack Instruction Manual

Page 1 of 5
939500539 Rev B
If you have a problem, question, or request, call
your local dealer, or Coalesse at 1.800.627.6770
Or visit our website: www.coalesse.com
©2010 Coalesse
San Francisco, California U.S.A.
Printed in U.S.A.
5/32" DRILL BIT
Field installing an X-Stack®Tablet Arm

2a
SCREW
ARM ASSEMBLY
1
SCREW
Underside of Chair
Page 2 of 5
939500539 Rev B
1. Remove plastic seat from chair frame by removing
one (1) screw on each side of bottom of chair.
2. If chair has arms, only the arm that is being replaced
by the tablet arm needs to be removed. Begin by removing
four (4) screws as shown (2a).

2b
2c
2d
Page 3 of 5
939500539 Rev B

3
4
1/2"
5/32" DRILL BIT
PLASTIC BRACKET
HORIZONTAL TUBE
RUBBER BUMPER
PILOT HOLE
Page 4 of 5
939500539 Rev B
3. Look for two (2) rubber bumpers or pilot holes on the bottom
front horizontal tube (between the two plastic brackets).
If missing, drill a pilot hole on bottom of front horizontal tube with a
5/32" drill bit, 1/2" away from the edge of the plastic bracket.
4. Attach bumper on each side using one (1) #10 x 1" long torx
head screw.
NOTE: Because the tablet arm assembly places more weight on
the front legs of the chair, these front bumpers are needed when
stacking the chairs with the tablet arm.
#10 X 1"
TORX HEAD SCREW

TABLET ARM ASSEMBLY
5
Page 5 of 5
939500539 Rev B
5. Align tablet arm assembly with side of chair. To
install tablet arm assembly, reverse steps 2a thru 2d
on pages 2 and 3. Attach with four (4) #10 x 5/8" torx
head screws.
6. Reattach plastic seat to chair frame using the same screws
removed in step 1.
7. Start using your tablet.