COFFEE CHAPS BREWVIE User manual

BREWVIE
INSTALLATION MANUAL

1. DIMENSION AND POSITIONING
- MACHINE SIZE : W 200 mm X L 440 mm X H 325 mm
- OPERATING(HOLE)SIZE : W 170 mm X L 410 mm X D 400 mm
- WEIGHT : ABOUT 10kg
- VOLTAGE AND POWER CONSUMPTION : AC 220v, 2,650w
- SCALE : Max 1kg

2. WATER CONNECTION
④ Connect the plug to a separate earthed wall socket.
①WATER-IN PIPE : Using the flexible hose(1/4") provided with the machine
②WATER-OUT PIPE : Using 1/2" flexible hose. End of hose should not be sunk into water.(Water can
flow backward)
WATER PURIFIER FILTER AND WATER FLOW CONTROL VALVE ARE RECOMMENDED FOR BETTER
PERFORMANCE
③STEAM-OUT PIPE : Using 1/4" flexible hose. End of hose should not be sunk into water.(Water can
flow backward)
①WATER-IN PIPE
그림 2-1
WATER
TAP
WATER
PURIFIER
FILTER
WATER FLOW
CONTROL VALVE
POWER CORD
③WATER-
OUT
PIPE
POWER
SWITCH
②WATER-OUT PIPE

How to connect water hose
Insert the tube into the
insertion slot with the
fitting clip.
Push the tube all the way
into the fitting to finish
the tightening.
After tightening, pull both fittings and
tubes to check if the tube does not come
off. At this time, the clip will come
out slightly as shown in the figure and
will hold the tube so that it will not
come off.
WATER FLOW CONTROL VALVE(PROVIDED WITH THE MACHINE)
TUBE SIZE
: 1/4"(Inch) OUT DIAMETER
Install between water filter and BREWVIE
flexible hose
1/4"(Inch) OUT DIAMETER
Install between Water filter
and flow control
valve. on water
-out pipe

3. WATER FLOW CHECKING
600 ~ 700 g / min
HOME screen Setting page Factory mode
4. Scale function
HOME screen Setting page SCALE Factory mode
③ The scale can measure from 0 to 999g.
RECOMMENDED FLOW RATE
① Press any place for 3 seconds at HOME screen.
② Empty the water inside the tank with DRAIN menu.
② Press SCALE to use SCALE function.
① Press any place for 2 seconds at HOME screen.
③ Screen changed to Setting page. Press ① location for three seconds.
④ Flow rate is automatically measured. Use the flow control valve to adjust to the
recommended flow rate. If the maximum flow rate is less than the recommended,
please use a pressurized pump.

※ Precautions during installing
* Strong vibration or shock may cause the product to malfunction. Please handle with care.
* Please be careful not to change the water-in and water-out connections.
* If you press the scale with strong force, it may cause damage. Please handle with care.
* There are protect tapes on Top plate of BREWVIE, Touch panel, and Scale. Please remove if needed.
* Power switch, water-in&out connections and power cords are located on the bottom of BREWVIE. Please
be careful not to damage these parts when installing BREWVIE.
① Measure the weight of the scale calibration weight. if any error occurs, remove the scale
calibration weight come back to setting page. press ①for 3 seconds to move to Factory mode.
② If measured weight is less than the scale calibration weight, please press - button. + button is for
the case measured weight is over than the scale calibration weight.
When press +,- button, scale setting changes 0.1g~0.2g.
③ After set Zero Point setting, measure the weight of the scale calibration weight again. When
setting is finished, remove the weight and press ②CAL button for three seconds. "101" displays and
setting is saved.
4 - 1) Set the scale to zero