Coleman 2300-511 User manual

The Water Hose Adapter connects a
standard water hose to
Hot Water on DemandTM.Once adapter
is in place and water is turned on at the
source, use Hot Water on DemandTM
to turn water on & off and to select
desired water temperature.
WATER HOSE
ADAPTER
Instructions for Use
Model 2300-511

Attach Water Hose Adapter to Hot
Water on DemandTM:
1. Remove water pump assembly:
a. Disconnect water pump electrical connection from
Hot Water on DemandTM (fig. 1).
b. Remove water
pump by releasing
the quick connector
(fig. 1). Electrical Connection
Quick Connector
fig. 1
Be sure Hot Water on DemandTM is turned off and no
water is running through unit. Operate unit from a
camp table or picnic table. Do not set it on ground to
use. (Water will drain when unit is off, preventing dam-
age in freezing temperatures.
Adapter Water
Inlet Fitting
Electrical
Connection
Quick Connector
Water Tubing
Clips
WATER HOSE ADAPTER
Parts Identifier

2. Connect Water Hose Adapter to Hot Water on
DemandTM:
a. Connect Water Hose Adapter electrical connec-
tion to Hot Water on DemandTM.
b. Connect Water Hose Adapter to Hot Water on
DemandTM by inserting Quick Connector.
c. Connect and tighten water hose to adapter water
inlet fitting.
d. Connect water hose to water source.
To Start Hot Water on DemandTM:
1. Turn on water at source (fig. 2).
2. Turn Hot Water on DemandTM Control Knob to
“COOL” until water
dispenses (fig. 3).
3. Turn Control Knob
to “OFF” (fig. 4).
4. To select desired
temperature setting,
turn Control Knob,
counterclockwise.
To Start Hot Water on DemandTM (continued):
fig. 2
fig. 3 fig. 4
To Remove from Hot Water on
DemandTM:
1. Disconnect Water Hose Adapter electrical con-
nection from Hot Water on DemandTM .
2. Disconnect adapter hose from Hot Water on
DemandTM by releasing the Quick Connector.
3. Reconnect Water Pump electrical connection
to Hot Water on DemandTM .
4. Reconnect Water Pump hose to Hot Water on
DemandTM by inserting the Quick Connector.
Attach Water Hose Adapter to
Hot Water on DemandTM (continued):

The Coleman Co., Inc. • 3600 N. Hydraulic • Wichita, KS 67219 U.S.A.
1-800-835-3278 • TDD: 316-832-8707
©2003 The Coleman Company, Inc. All Rights reserved.
Coleman® is a registered trademark of The Coleman Company, Inc.
For information regarding other
Hot Water on DemandTM accessories:
Visit us at
www.coleman.com
2300-052 (05/03)
Maintenance:
To Clean:
1. In a clean container mix one-gallon of water with 6 oz. of a calcium, lime, and rust remover solution
(available at hardware, general merchandise and food stores).
2. Disconnect water hose adapter from unit.
3. Unscrew water tubing from adapter body.
4. Detach clips from water tubing.
5. Submerge water tubing in cleaning solution. Allow to set five (5) minutes.
6. Run clean water through water tubing.
7. Air dry.
8. Reattach tubing to Water Hose Adapter and reattach clips to water tubing.