Connector mount bracket
【 Features 】
● This is a connector mount base for direct mounting of ICOM IC-705 radio and
YAESU FT-817ND, FT-818ND.
● The angle can be changed to match the installation angle of the radio.
● BNC-LP, SO-239 Adapter cable is included.
● Holes are provided for SMA-J and BNC-J bulkhead types to be mounted.
MODEL CST-30
Notes on installation and installation
!
■Tighten all screws securely to prevent unexpected tipping or falling off.
■An antenna that is too long may not be able to hold its angle due to poor balance.
Make sure that the antenna can withstand the installation before installing it.
[How to use]
Refer to the figure below for installation.
When attaching the bracket to YAESU FT-817ND, FT-818ND, it will be easier to
attach the cable if the upper bracket direction is opposite.
Product Specifications
Bracket dimensions : 53(W) x 32(D) x 68(H) [mm]
Bracket weight : approx. 70g
Material : SUS304 [Main body], Brass [Screw]
BNC-LP to SO-239 Adapter cable
Cable length : approx. 130mm
Instruction Manual
Thank you for purchasing our products.
For your safety :
Read this manual carefully for proper handling and operation before using.
Keep this manual in a safe place for future reference.
For installation on ICOM IC-705
For installation on YAESU FT-817ND,FT-818ND
Screws for fixing to the
enclosure are not included.
Turn the IC-705 in the
opposite direction from
when it was installed.
Only one knurled knob is used.
Accessories:
■ 2 screws with knurled knobs
■ BNC-LP to SO-239 Adapter Cable
IC-705 GND terminal
