Comfort Star CHH009CA-13B User manual

CHH009CA-13B
CHH012CA-13B
66129903140 CHH012CD-13B

CONTENTS
18
17
9
8
7
4
2
16
14
11
10
9
1

1
NOITAREPO DNA ERUTCURTS
Window
receiver
1

The instructions before use
2
STRUCTURE AND OPERATION
ower supple when not us-
ing the air conditioner for
Be sure to cut off thep-
a long time.
2

3
STRUCTURE AND OPERATION
The power cirds of this air con-
ditioner adopt Y-type connecti-
on,please donÿt cut off or da-
trol.If the supply cord is its ser-
vice agent or similarly qualified
magethe power cords and con-
ard.
persons inorder to avoid a haz-
3

CANCEL
Note:
Be sure that there is on obstruction.
Don't drop or throw the remote control.
Don't place the remote control in a location exposed to direct sunlight.
Whe the unit is restarted after stopped,it can automatically resume its most latest
running mode,and the outdoor unit starts a little bit later.
Name and Function-Remote conteol
SLEEP Button
FAN SPEED Button
MODEButton
Clock Button
TEMP+ TEMP- Button:
Under the COOL, DRY, FAN
or HEAT mode, press these
two buttons could set the
temperature, the temp. setting
range is ćć, the temp.
can be memorized under each
modes.
Under COOL, DRY, HEAT
mode, press the button once
start the SLEEP function, when
repressing once more, to stop
the function.
When the unit start up, under the
AUTO,COOL,FAN,HEATmode,
press this button, could select
Auto fan, Low fan, Middle fan,
High fan, at DRY mode, the
fan speed is Low fan speed.
The FAN SPEED can be
memorized under various
modes
At unit turned on, press this
button, the AUTO, COOL, DRY,
FAN or HEAT mode could be
selected.
When pressing this button once,
the icon of CLOCK will flash, and
that could be adjusted.
At CLOCK adjustment, press
the TIME+ once, the ones place
on the minute will be increased
1, and continuously press 1sec
above, the tens place on the
minute will be increased 1 in
everyhalf second. When pressing
the TIME-, the ones place on the
minute will be decreased 1, and
continuously press 1sec above,
the tens place will be decreased
1in every halfsecond.Afteradjusted
pleasepress the CLOCKbutton
againfor confirming.
5
STRUCTURE AND OPERATION
4

Note:
This type of remote control is a kind of new current.Some buttons of the control
which have extra function will be described below.
Name and Function-Remote control(continue)
Liquid crystal displayer a
It shows all set contents.
ON /OFF Button
T-OFF Button
T-ON Button
SWING Button
TIME+ TIME- Button CANCEL Button
Function instruction please
refer to T-ON button, T-OFF
button, CLOCK button.
Press this button once, cancel all
TIMER setting.
At unit turned on, press this button
once to start the SWING function,
when press the button once again
will stop.
Press this button once will enter
into T-OFF setting, the icon of
T-OFF will flash, the T-OFF button
is available in ON or OFF mode,
the setting method is the same
with T-ON.
Every press of this button,
the unit will be turned on,
when repressed, the unit will
be turned off.
When pressing this button
once, enter into T-ON setting,
the icon of T-ON flash, every
press of TIME+, the time of
T-ON will be increased 1min.
When continuously press 1sec
above,the tens place on minute
will be increased 1, every press
of TIME- will be decreased 1
minute, when continuously
press 1sec above, the tens place
on minute will be decrease 1 in
every half second, and it goes
round with 12hours.
6
STRUCTURE AND OPERATION
5

Don't confuse the new and worn or different batteries.
Remove batteries when not in use for a longtime.
The batteries can be used for about one year.
The remote control should be lm or more away from television or audio device.
How to insert batteries
1.Remove the cover from the back of the remote control.
2.Insert the two batteries(Two AAA dry-cell batteries).
3.Re-attach the cover.
NOTE:
7
STRUCTURE AND OPERATION
6