Comfort Zone CZST162BTE Series User manual

www.comfortzoneproducts.com Save These Instructions
Features:
• Patented Fast Assembly Quad-Pod® Folding Base
(US Pat. No D643230 and D646501)
•Wide Area Oscillation
•Rotary Knob with 3 Speed Settings
•High Performance Blades
•Adjustable Height and Vertical Tilt
•Simple Assembly is Required
• 120V A.C. / 60Hz.
CZST162BTE Series
16" Oscillating Stand Fan

2
2
www.comfortzoneproducts.com
INTENDED USE:
This product is intended for indoor residential and ofce use only,
not for industrial or other commercial applications. Use only with
electrical wiring that is in good working order and that meets
applicable codes and ordinances. If you have any questions
whether your wiring is adequate, consult a qualied electrician.
While using your fan, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we
have used the word "WARNING" to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result
in injury or death.
IMPORTANT INSTRUCTIONS
As with all electrical appliances, basic safety precautions should
always be followed to reduce the risk of electric shock, re, or
injury to persons, including the following precautions:
• Read all the instructions before using this fan.
• Use this fan only as described in this manual. Any other use not
recommended by the manufacturer may cause electrical shock,
re or injury to persons.
• Do not operate the fan with a damaged power cord or after the
fan malfunctions or has been dropped in any manner.
• Use of extreme caution is necessary when any fan is used by or
near children, disabled persons or pets and whenever the fan is
left operating unattended.
• Do not place the fan on a small, unlevel, uneven or any surface
which might allow fan to tip or fall.
• For proper operation, fan should be placed on a smooth,
non-combustible, level surface.
• Always unplug fan when not in use, when moving from place
to place, when assembling or disassembling parts, and before
cleaning.
• The use of attachments, not recommended or sold by the
manufacturer, may cause hazards.
• Do not use outdoors.
• Do not use fan in window. Rain may cause electrical hazard
(for non-window models).
• Do not operate the fan with blade guards or any safety device
removed.
• Avoid the use of extension cords due to risk of re. If an
extension cord must be used, the cord must be minimum
14 AWG and rated not less then 1875 watts.
• Do not run power cord under carpeting. Do not cover cord with
throw rugs, runners or the like. Arrange cord away from trafc
area where it will not be tripped over.
• Do not insert or allow any object to enter any openings on the
fan. Doing so may cause electric shock and/or re hazard.
Avoid contact with moving parts.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure they do not play with
the appliance.
READ & SAVE THESE
INSTRUCTIONS
WARNING: SHOCK HAZARD
Use your fan only in dry environments. This fan is not intended
for use in a bathroom, laundry area, or similar locations, or near
sinks, washing machines, swimming pools or other sources of
water. Never locate fan where it may fall into a bathtub or other
water receptacle. Do not use in damp environments such as
ooded basements.
WARNING: HOT SURFACES
Do not touch fan motor when in use. This motor is hot when in
use, to avoid burns, do not let bare skin touch hot surfaces.
WARNING: FIRE HAZARD
Fans have arcing or sparking parts inside. Do not use near
combustible materials or ammable gases or sources of heat.
DO NOT USE in areas where gasoline, paint or ammable
materials are used or stored. To prevent a possible re, do not
block air intakes or exhaust in any manner. Do not insert or allow
foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock, re, or damage the fan.
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
CAUTION: TO PREVENT ELECTRIC SHOCK,
this product has a polarized two prong plug (one blade is wider
than the other) that must be fully inserted in to a matching
properly grounded outlet. This plug is designed to t a polarized
outlet only one way. If the plug does not t fully into the outlet,
reverse the plug. If the plug still does not t, contact a qualied
electrician. Do not attempt to defeat this safety feature
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, do not use this product with any
solid-state speed control device.
DO NOT operate any fan with a damaged cord or plug or after
fan malfunctions, has been dropped or damaged in any manner.
Do not operate fan with a broken blade, safety cage or any visual
imperfections. Disconnect power before servicing. For repairs
covered under warranty, see warranty statement. For all other
repairs contact Comfort Zone®Customer Service by telephone or
mail for information and assistance.
DO NOT run power cord under carpeting. DO NOT cover cord
with throw rugs, runners or the like. Arrange cord away from
trafc area where it will not be tripped over. Avoid the use of
extension cords due to risk of re. If an extension cord must
be used, the cord must be minimum 14 AWG and rated not
less then 1875 watts. Do not use an extension cord unless the
plug can be completely inserted into its receptacle. Unplug
the fan when not in use. Do not operate fan with its ventilation
obstructed.

3
3
www.comfortzoneproducts.com
USAGE:
Fan Operation: Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location: Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection: Plug fan directly into 120 volt A.C., 60 Hz wall
outlet. Be sure plug ts tightly in outlet. A loose connection may
cause overheating and damage to the plug or fan.
Note: To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
CONTROL PANEL:
Turning Fan On/Off: Place fan on stable level surface. Plug fan
into properly grounded outlet. To start the fan, rotate the Knob: 0,
3-HIGH, 2-MED, 1-LOW. Press 0-OFF to discontinue use. Unplug
fan when not in use.
Oscillation: To start fan oscillation, press Oscillation Control
Knob (located above motor housing) down. To stop oscillation
function pull Oscillation Control Knob up while the fan is in any
oscillation position.
Fan Assembly:
Simple assembly is required to use this fan.
Step 5
Step 7
Step 8
Unfold patented Quad-Pod®
base legs.
With collar nut loosened,
pull Chrome Extension
out of Fan Pedestal.
Place decorative Plastic Flange
over Extension Pole to cover
the base. Slide pedestal pole
into base receptacle. Tighten
nut to secure in place. Slide
ange over base connection.
Remove the Blade Cap by
twisting it CLOCKWISE while
holding the metal shaft tightly.
Note: Threads are reversed
Unscrew = Clockwise.
Step 1 Step 2
Step 3
Pull
Chrome
Extension
Out
Step 4
Assemble fan Control
Panel/Motor assembly
onto Chrome Extension
and tighten thumb screw.
Thumb
Screw
Step 6
Assemble Rear Grille
onto Motor Housing.
Rear Grille should t
into pins on fan motor
housing as shown.
Thread Locknut onto
Motor Housing to lock
Rear Grille in place.
Pin Slot
Step 9
T
i
g
h
t
e
n
Remove any protective
covering over shaft before
Fan Blade Installation. Place
Fan Blade onto Motor Shaft.
Notice the pin on Motor Shaft
should t into slots of Fan
Blade.
With logo upright, attach
Front Grille to Rear Grille by
snapping them together. Be
sure all 8 clips are secure. Do
not operate fan without grille
in place.
Thread Blade Cap onto
threaded end of Motor Shaft.
Note: Threads are reversed.
Tighten = Counter-clockwise.
Step 10
Oscillation
Control
Knob
Power and
Speed
Control
Rotary
Knob
L
o
o
s
e
n
Pin
Pin Pin
Lock Nut
Pin
Pin Pin

4
4
www.comfortzoneproducts.com
Rev. 09/16/21
LIMITED WARRANTY
This unit is guaranteed to the original retail
purchaser against defects in quality or workmanship
for a period of one year from the date of original
purchase. If this unit fails because of a manufacturing
defect within 30 days of purchase, return the unit,
with your receipt, to the retailer. After 30 days, but
within the warranty period, if the unit was purchased
within the continental United States, return it, freight
prepaid, to World and Main for repair or replacement.
If the unit was purchased outside the continental
United States, return the unit to the place of
purchase. This warranty does not cover damage
caused by misuse, abuse, overheating or alteration.
Repairs made by anyone other than World and Main
are not covered in this warranty. World and Main will
not be held liable for any losses due to neglectful
operation. All implied warranties, including the
warranties of merchantability and of tness of
purpose, if applicable, are hereby limited in duration
to the period of one year from the date of original
retail purchase. Some states do not allow limitations
on how long an implied warranty lasts, so the above
limitations may not apply to you. Incidental or
consequential damages arising from a breach of
either express or implied warranties are hereby
disclaimed and excluded. Some states do
not allow the exclusion of limitation of incidental
or consequential damages, so this limitation or
exclusion may not apply to you. Upon the expiration
of this warranty all such liability will terminate. No
other warranties are expressed or implied.
This warranty gives you specic legal rights, and you
may also have other rights which vary from state to
state. No informal dispute settlement mechanisms
are available. This limited warranty is given in lieu of
all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Fig 1 Fig 2 Fig 3
Slide Cover to Open
Care and Maintenance
Cleaning: CAUTION-Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille
surface with a clean damp cloth. Do not use harsh chemical
or abrasive cleaners. DO NOT IMMERSE THE FAN OR ANY
WIRES IN WATER. Replace front grille before fan use. Allow
fan to dry completely before use. Periodic grille cleaning with
a vacuum will prevent dust build up. The motor is sealed and
does not require any interior maintenance, cleaning or
lubrication.
Maintenance: The Internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
Repair: DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR
BECOME DAMAGED IN ANY WAY.
Storage: Keep original carton for storage of the fan. Coil and tie
the power cord to avoid damage during storage.
Note: Some models come with a plug where you can replace a
fuse. If your model has this, please read and follow the below
instructions to replace the fuse.
This product employs overload protection (fuse). A blown fuse
indicates an overload or short-circuit situation. If the fuse blows,
unplug the product from the outlet. Replace the fuse as per
the user servicing instructions (follow product marking for
proper fuse rating) and check the product. If the replacement
fuse blows, a short-circuit may be present and the product
should be discarded or returned to an authorized service facility
for examination and/or repair.
Fuse Replacement:
1. Grasp plug and remove from the receptacle or other outlet
device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on top of
attachment plug towards blades. See Fig. 2.
3. Remove fuse carefully. Use a small tool to pry the end of the
fuse from holder cavity. Be careful not to break glass window.
4. Replace fuse. WARNING: Risk of re. Replace fuse only with
identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm).
Besure fuse is properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed
position.