Continental Refrigerator SRX User manual

SRX / TCS (FIXED HEIGHT) VOLLEYBALL POSTS
SAFETY REGULATIONS
In order to reduce the risk of injury and to assure secure functioning of the apparatus, rules mentioned
below are to be strictly followed:
1. Use this apparatus only under the supervision of a trained and qualified instructor.
2. Check this apparatus for proper stability before each training, use it only in perfect technical
conditions.
3. Always check the apparatus for its correct installation, particularly for the fixation mechanism,
before each use. If there are any doubts, do not use the apparatus and get a professional
check.
4. Please consider your own limits and the restrictions of this apparatus.
5. Obstructive items or persons in close proximity of the apparatus are not allowed.
6. Provide appropriate safety zones in the surroundings of the apparatus.
7. Never use the apparatus under the influence of alcohol, medication or drugs.

8. Pregnant women or persons with health issues should not use the apparatus.
9. Do not attempt to repair any damage to the apparatus yourself but contact your supplier for
advice or technical assistance.
10. Any unauthorised repair, alternation, removal of parts or change of specifications of the
apparatus are strictly prohibited for reasons of safety and will automatically and immediately
and without any prior notice end any warranty or right of compensation in any form
whatsoever.
GENERAL ADVICE
The life period of apparatus is limited. Also materials wear after a certain period of time. Please check
all parts, which are subject to severe wear and tear, at least once every 3 months. This is mainly
relevant for the security of adjustable parts and mechanisms, e.g. rails, bars, rings. Replace any worn
off, defective and missing parts. If there are any doubts, ask for advice from one of our specialists.
For security reasons, we suggest to perform a maintenance check of all apparatuses and mats by a
specialist, once a year. This check can be part of a yearly or six month safety check.
This apparatus is designed to be used in dry conditions only.
ASSEMBLY AND USE
The setup and storing of this device may only be undertaken by competent adults who have
read and understood the safety regulations of this manual.
1. Place both the volleyball post with TCS tensioning system (1) and the post with the
net attachment (2) in the floor sockets (3). Make sure the attachment points point
inwards
2. Attach one end of the net (4) to the volleyball post with the net attachment. Make
sure there are some chain links (5) between the attachment to the post and to the net
itself
3. Attach the other end of the net to the cable of the TCS tensioning system at the
opposite post
4. Move the sliding strip (6) at both volleyball posts to a height where the cable has a
height of 2.45m measured from the floor and tension the net with this setup.
IMPORTANT NOTE: The measurement shown on the posts are not the height of the net
measured from the floor. This is not possible due to different socket depths and floor
thicknesses in different facilities. The printed measurement are a guide to help assist with
setting up once you have calibrated the measurements to suit your facility.
5. To tension the net, turn the lever clockwise. The correct tension can be read under the
position of the steel cable. The correct tension of the Schelde net is indicated with the
Schelde logo.
NOTE: When setting up the volleyball set for the first
time, while tightening the net the cables may stretch
and become too long. If this occurs, one of more links
can be removed from the chain to achieve the correct
tension

6. Slide the short sliding strip against the long sliding strip. Attach the bottom cord to the sliding
strip and then slide it down to further tension the net. Do this on both sides until the net has a
height of 2.43m in the middle.
7. Use the VELCRO fasteners to attach the side of the net to the posts
8. Attach the sleeves of the antennae to the net
9. When everything is set up and measured correctly, the small orange stickers that are included
can be placed on the sliding strips. In the case of the setup described above (2.43m) place
the sticker next to the volleyball + “male” symbol. With the same combination of posts and
sockets this can now be used for the height adjustment of future setups.
NOTE: The height indication on the post is not the height measured from the floor. This height
indication on the post together with the orange stickers on the sliding strip is an assist for the
adjustment of future setups and may only work if the same combination of floor sockets and
posts is used)
NOTE: To disassemble the volleyball set, the above steps should be followed in reverse order. Make
sure that the tensioning mechanism is turned back completely before removing the net.