Coppernic C-One2 User manual

C-One2
Quick Start and Regulatory Guide
QSG 180190 A20
| Non-Contractual Pictures |

QSG 180190 A20
C-One2
Quick Start and Regulatory Guide
WHAT'S IN THE BOX ?
C-One2 HF ASK
C-One2 HF iClass | LF Prox
C-One2 HF LEGIC | LF TM
C-One2 LF Agrident
Page 02 | 12
DEVICE
NOTICE
BOX
1
2
3
HANDSTRAP
CABLE MICRO USB | USB A
STYLUS
4
5
6
PLUG | EUROPE
POWER SUPPLY
TEST REPORT
7
8
9
1 2 3
4 5
6 7 89
OR

C-One2
Quick Start and Regulatory Guide
PRODUCT OVERVIEW
led indicators
4.5’’ touch panel
programmable key |
scan key (P2)
micro SD | micro SIM door
microphone
micro USB
microphone
flash
camera
2D imager
RFID antenna
speaker
programmable key |
scan key (P1)
handstrap holder
programmable key (P3)
power key
handstrap holder
| Non-Contractual Pictures |
RFID antenna
C-One2 HF ASK
C-One2 HF iClass | LF Prox
C-One2 HF LEGIC | LF TM
C-One2 LF Agrident
Page 03 | 12
QSG 180190 A20
tether
back
touch keys
menuhome
receiver
volume keys +/-

C-One2
Quick Start and Regulatory Guide
Setting up your device
CAUTION
Failure to completely reseal the Micro SD | Micro SIM card slot cover may lead to water or other liquids entering the casing
which may cause damage to the device.
MICRO SIM card installation
•Open Micro SD | Micro SIM door.
•To remove the Micro SIM card: Insert a removal tool (pin type) into the hole then push until the tray pops out.
•Put the Micro SIM card on the tray.
•Insert Micro SIM tray into SIM slot.
•Close the door after installation.
MICRO SD card installation
•Open Micro SD | Micro SIM door.
•Insert Micro SD card into Micro SD card slot.
•Close the door after installation.
NOTE
Micro SIM card and Micro SD card should be purchased separately.
Page 04 | 12
QSG 180190 A20

CAUTION
Please make sure the device being charged fully when using C-One²at first time.
Please ensure the Micro USB port clean and dry before inserting aUSB cable for charging to avoid the operating issues on the device.
Please remove water or moisture from the Micro USB port instantly with soft cloth when the device gets wet, to avoid the
operating issues on the device.
Charge the BATTERY
Before using the C-One²charge the battery using one of the following accessories approved by COPPERNIC:
1. Insert the micro USB cable into the C-One²and USB Acable into the power supply.
> Cable Micro USB | USB A is included in the device box.
> Power supply is included in the device box.
2. Insert the Jack Power Adapter into the docking station and the USB Acable into the power supply.
> Cable USB A | Jack Power Adapter is included in the docking station box.
> Power supply is included in the docking station box.
> Cable Micro USB | USB A is included in the docking station box.
Setting up your device
Page 05 | 12
C-One2
Quick Start and Regulatory Guide
QSG 180190 A20
BACK VIEW

C-One2
Quick Start and Regulatory Guide
Setting up your device
LED indicators
LED1
LED2
Red
LED blinks (LED1) Low battery
Red
LED (LED1) Battery is charging
Green LED (LED1)
Battery is fully charged
Blue LED
blinks (LED2) BT devices connected or receiving messages/notifications
Page 06 | 12
QSG 180190 A20

C-One2
Quick Start and Regulatory Guide
Using your device
TURNING ON | TURNING OFF your device
Power Off | Press and hold during 5 sec. the power button and select “Power off” in the dialog box.
Reboot | Press and hold during 5 sec. the power button and select “Reboot” in the dialog window to restart the
device.
Suspend Mode | Press and release the power button to place the device in suspend mode. The display will
be off and go into a low power state to conserve battery power.
Reset | Press and hold the power button during 30s.
Page 07 | 12
QSG 180190 A20

C-One2
Quick Start and Regulatory Guide
Using your device
DATA CAPTURE | photos & videos
Use the rear camera to take photos and capture video.
1. Go to Home Screen > select “Camera” > Tap camera icon or screen to take a picture/switch to video icon and tap for
video recording.
2. Using the rear camera to take photos and capture video.
NOTE
Ensure device memory or extend Micro SD card space is available.
DATA CAPTURE | barcode scanner
CAUTION
Class 2laser when open.
Do not stare into beam or view with optical instruments.
Complies with 21cfr1040.10 and 1040.11 except for deviations pursuant to laser notice no.50,dated June
24,2007 and IEC/EN 60825-1:2014.
NOTE
Please remove the protector film before using scanner.
Scan with the imager
•Use "barcode manager" provided by Coppernic.
Side-Key Remapping for scanning
•Go to "Settings" >Select "Remap key & Shortcut"
•Select the key (P1, P2 : blue side keys) >Tap Remap Key >Tap Barcode Scan
•The red laser aiming pattern turn on to assist in aiming, scan ready when beep sounds
•Release the scan button.
Page 08 | 12
QSG 180190 A20

C-One2
Quick Start and Regulatory Guide
Using your device
RFID
C-One2HF ASK - C-One2HF iClass | LF Prox - C-One2HF LEGIC | LF TM with RFID options to read, please put the TAG/CARD
on the RFID area.
C-One2LF AGRIDENT with RFID options to read, please put the TAG/CARD on the RFID area.
RFID READING AREA
OPTION
Stick LF AGRIDENT antenna
RFID READING AREA
RFID READING AREA
Page 09 | 12
QSG 180190 A20

C-One2
Quick Start and Regulatory Guide
Regulatory information
CAUTION
Only use COPPERNIC approved accessories.
Operating frequencies C-One2
EUT Type
Handheld
Device
Brand Name
COPPERNIC
Model Name
C
-ONE²/C-ONE²(WOS)
Tx Frequency Bands
(Unit: MHz)
GSM 900 : 880 ~ 915
GSM 1800 : 1710 ~ 1785
WCDMA Band I : 1920 ~ 1980
WCDMA Band VIII : 880 ~ 915
LTE Band 1 : 1920 ~ 1980
LTE Band 3 : 1710 ~ 1785
LTE Band 7 : 2500 ~ 2570
LTE Band 8 : 880 ~ 915
LTE Band 20 : 832 ~ 862
LTE Band 28 : 703 ~ 748
WLAN : 2412 ~ 2472, 5180 ~ 5320, 5500 ~ 5700
Bluetooth : 2402 ~ 2480
RFID option HF ASK: 13.56MHz
RFID option LF AGRIDENT: 134.2KHz
RFID option HF
iClass : 13.56 MHz
RFID option LF
Prox : 125KHz
RFID option HF LEGIC
: 13.56 MHz
RFID option LF TM
: 125KHz
GPS : 1575.42
Maximum AVG Conducted Power
(Unit: dBm)
GSM 900 : 33.78
GSM 1800 : 31.12
WCDMA Band I : 23.68
WCDMA Band VIII : 23.77
LTE Band 1 : 24.52
LTE Band 3 : 23.98
LTE Band 7 : 23.97
LTE Band 8 : 23.99
LTE Band 20 : 23.99
LTE Band 28 : 23.94
802.11b : 15.83
802.11g : 16.72
802.11n HT20 (2.4GHz) : 16.76
802.11n HT40 (2.4GHz) : 15.83
802.11a : 15.13
802.11n HT20 (5GHz) : 15.17
802.11n HT40 (5GHz) : 15.30
802.11ac VHT80 : 14.82
Bluetooth : 2.36
NOTE : C-One²: Maximum reported SAR value (10g) Body: 1.71W/kg @5mm
Page 10 | 12
QSG 180190 A20