Creative Playthings WILL9WPP8 User manual

WILLIAMSBURG PREMIUM PACK 8
WILL9WPP8-100 Rev B (07-18)
© Copyright 2018, Creative Playthings
CHILDHOOD STARTS HERE
WILL9WPP8
W P P 
Cartons for this Play Set:
1 63006-421 Williamsburg Box 1 (Hardware)
1 63006-422 Williamsburg Box 2
1 63006-423 Williamsburg Box 3
1 63006-445 Williamsburg Roof (Hdwre & Instr)
1 SH946-102 Access Ladder, 5ft
1 63058-202 4 Position Swing Beam
1 63060-222 9ft Swing Beam Legs (Hdwre & Instr)
1 50546-777 3 Swings, 1 Trapeze
1 15166-400 10 ft. Super Wave Slide
1 AH201-102Q Rock Climber (Hdwre & Instr)
1 SC907-800Q Williamsburg Play Walls (Hdwre & Instr)
1 SC908-800Q Williamsburg Play Floor (Hdwre & Instr)
1 63081-102 Ice Cream Stand (Hdwre & Instr)
1 AG942-400 Access Ladder Handles (Hdwre & Instr)
1 AG943-400 Slide Handle (Hdwre & Instr)
1 SM964-402 Gable Fans (Hdwre & Instr)
1 SM963-402 Dormer (Hdwre & Instr)
• Start by assembling the Williamsburg tower. Instructions and
hardware are in the cartons noted at left.
• Wait to install the Access Ladder, Slide, and Wall Slats until after
the rest of the play set is complete.
• Wmsbg step 7. Do not install the safety rail. It will be used for the
Play Walls.
• Wmsbg step 8. Do not install the angle brace mounted to the
back platform end nearest the swings. It will interfere with the
chalkboard.
• Wmsbg step 15. No Swing Mount is needed.
After completing the tower except Access Ladder, Slide, and Wall
Slats:
• Using a ladder, install the Dormer (SM963-402) in the position
shown. Ladder access may be obstructed by later installations.
The components of this gym can be combined with others to create different play sets.
This is the best order of assembly to create this specic set.
Read this sheet and all instructions included with the different parts before assembly.
See the Instructions and Owner's Manual included in carton 63006-445 for important
safety information.
Dimensions of assembled package:
19' 4" wide x 14' 6" deep x 11' 6" tall

© Copyright 2018, Creative Playthings
WILLIAMSBURG PREMIUM PACK 8
WILL9WPP8-100 Rev B (07-18) Page 2
Gable Fan
Ice Cream
Stand
Swing Beam
Dormer
Rock Climbing
Wall
Play Walls
• Install the Gable Fans (SM964-402).
• Install the 9ft Swing Beam. Instructions are in carton 63060-
222.
• Install the Play Floor (SC908-800Q).
• Install the Play Walls (SC907-800Q) on front and swing side
of the tower.
• Install the Ice Cream Stand (63081-102) on the back of the
tower.
• Install the Rock Climbing Wall (AH-201Q) in the postion
shown.
• Place the access ladder and slide as shown in the picture
on the preceding page. Check spacing.
• Fasten access brackets to the inside of the ladder rails.
Secure the access ladder using the method shown in step
17 of the Williamsburg instructions.
• Fasten the Access Ladder Handles (AG942-400) to the Ac-
cess Ladder.
• Install the slide mount and slide using the method shown in
steps 23 and 24 of the Williamsburg instructions.
• Install wall slats in the positions shown on the front page,
using the methods from the Williamsburg Instructions. Gaps
must be narrower than 3-1/2" or wider than 9" to prevent
potential head entrapment.
• Mount one hand grip to the entrance wall slat between
the ladder and the slide. Mount the other hand grip to the
adjacent post at the same height, using 1/4 x 1-1/2" lag
screws and 1/4" at washers. Drill 3/16" diameter pilot
holes for the lag screws.
• Mount the Slide Handle (AG943-400) above the Super
Wave Slide.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.