
Setup Instructions:
(Please check out the Instruction video on the website: www.crocpad.com )
Step 1:
Make sure there are no sharp objects under the product which might puncture the
vinyl then lay out the slide facing up on a flat surface.
Step 2:
Locate the valves. The main air chamber has a valve and the two side rails have
valves.
Using the Crocpad electric pump, lock the adaptor onto the end of the pump
hose and insert into the valve body with the special inflation adaptor which is
included with the pump. Turn ¼ turn to lock in place.
Step 3: (Inflate the slide)
Using an electric inflator or pump, inflate the main (1) chamber first until
firm. Close the valve by screwing the cap back on. Inflate one side rail until
firm (2), Repeat for the other chambers (3).
Step 4: (Fill the stepping pad (4) with 20L of water then inflate it)
Using the water hose adapter which can be found in
the repair kit, fill the stepping pad with water (20L) to
secure the slide and prevent it from moving.
After you put 20L of water, remove the hose adapter
and start inflating the stepping pad until firm.
Step 5: (Anchor the slide to the stepping pad)
Use the stainless connectors to connect the slide and
stepping pad.
Note: In windy conditions and in order to have the slide stabilized use the D
rings at the front-bottom of the slide to anchor it to an anchor bag.
(You can buy a Crocpad Anchor bag online)
Cleaning and Storage:
1. Empty the water from the stepping pad (4) completely.
2. Deflate the Slide and Stepping pad.
3. Wipe off with a towel and let it dry before you put it in the storage bag.
4. Keep in a cool, dry place, away from fire and sharp objects.