Crossray TCE15TR User manual
1
CROSSRAY EECTRIC
TREKITCE
PRODUCT INSTALLATION MANUAL
ET
TCE15TR
EK
TCE15KIT
1
Phillips Head Screw 3/16"x3/8"
Qty.16
2
Install CROSSRAY Trolley.
TCE15TRR Assembly Instructions
2 Install Casters.
3
Install Side shelf, bracket onto BBQ.
4
4
Phillips Head Screw 3/16"x3/8"
Qty.8
Insert the BBQ onto the trolley,and secure it with screws from underneath.
Phillips Head Screw 3/16"x3/8"
Qty.4
3
5
5 Install the side shelves.
6 To remove the side shelves, lift a shelf, let the
end rotate down (45°), then lift itoff the grill.
1 Install Casters.
2
Phillips Head Screw 3/16"x3/8"
Qty.16
Install Trolley side panels.
Phillips Head Screw 3/16"x3/8"
Qty.6
6
TCE15KIT Kitchen Cabinet Assembly instructions .
3 Install Trolley Rear panel.
Phillips Head Screw 3/16"x3/8"
Qty.9
4
Phillips Head Screw 3/16"x3/8"
Qty.4
Rear panel,Lower Rear panel,Upper
Install Door Bracket.
7
5
Double screw 3/16"x3/8"
Qty.4
1.
2.
8
Install middle panel.
Install the screws.
Slide in the midde panel.
6
Phillips Head Screw M6X20
Qty.4
1. Pre-install the screws partially on the Table plate
(Do not tighten to the end).
2.
9
Install countertop.
Position the pre-installed Screws on
the cabinet (Handle with care).
7 Install Door
10
Tilt the door and insert to the hole on bottom.1.
Tilt the door to an angle.
2.2.Press the latch on the door, and slide
the door into the hole when the latch is
flush with the door support piece.
11
8 Install Trim brackets.
Countersunk Flat Head
Screw 3/16"x3/8"
Qty.4
Thermofilm Australia Pty Ltd
17 Johnston Court Dandenong South, Victoria, 3175 Australia
t: 03 9562 3455 e:[email protected]
How to adjust the height of the caster with leveling glide.
12
1.When you want to move the cabinet, please lift the leveling
glide with wrench as shown on below image (please keep
the leveling glide off the floor 3-5mm).
2.When you want to level the cabinets., please use
a wrench (not included) to adjust the leveling-caster.
The maximum height of adjustment is 5-6mm.
This manual suits for next models
1
