Crosswave Cordless 2588F User manual

My CrossWave®Cordless Multi-Surface Wet Dry Vac
shuts off automatically | Support
•Turn machine on by select a cleaning mode (Rug or Hard Floor)
•If machine does not turn on, refer to No power troubleshooting
•Remove the handle by using a screwdriver or other blunt object to press the white tab found behind
the clean tank
•
oPull up on the handle to remove
oReinsert handle into the machine - you should hear a click when secure

•Recline machine to activate brush roll
oIf brush roll does not turn or machine shuts off after a short time turn machine off by pressing the
Hard Floor button
•Remove brush roll window by grabbing the pull tab and pulling upward
•Hold brush roll tab and pull upward to remove brush

•Check ends of brush roll for wrapped debris or hair
•Hold the colored pull tab on brush roll and spin the other end
oIf the brush doesn't spin, a new one needs to be ordered

•Check the plastic gear end on the machine and remove hair or debris wrapped in this area
oTurn gear by hand to test spin
•Reinstall the brush roll by inserting the gray tipped end into the right side of the machine and then
pressing down on the colored tab until it clicks into place
•Reattach the brush roll window
oLine up tabs on the front edges of the foot and then push the window into place until it clicks

•Turn machine on, recline, and test to see if CrossWave turns on and will run
oIf not, please contact us