Crosswave Cordless 2588F User manual

My CrossWave®Cordless Multi-Surface Wet Dry Vac
has no suction | Support
•Remove machine from docking station
•To activate suction, press "Hard Floor" or "Rug" button on handle
•If machine does not turn on, see No Power Steps
•Remove dirty water tank by pressing down on the recessed button on the top of the tank

•With the machine on and a floor type selected, feel for suction strength at the motor vents (on the
upper portion of where the top of the dirty tank connects)
oIf no suction, visit a BISSELL Authorized Service Center or Contact Us
oIf suction is strong, continue troubleshooting
•Empty dirty water tank by grasping the top of the tank at the sides and pulling up to remove the top
•Remove strainer from tank and discard debris
•Remove filter and clean any debris

•Hand wash filter, screen, and float with warm water
•
oManually move the float up and down to ensure it moves freely and is not stuck in place
•Replace filter (after it has dried) - be sure the edges are smooth and not folded over

•Check for a black rubber gasket around the top portion of the dirty water tank
oIf it is missing, a new dirty water tank should be ordered
•After parts dry completely, reattach the tank
•Angle the water tank back into the body of the machine bottom first - push tank in until it clicks
oTank should NOT be loose or have any gaps when installed on machine
•Turn machine on and test for suction
oIf still no suction, turn machine off
•Remove the dirty tank, remove the brush window
•Clear any clogs in the debris pathway in the dirty tank pocket

•Also clear debris from the suction pathway on the foot
•Reattach the dirty tank and brush window and test for suction
•If still no suction, contact us