Cutting-Edge-Creations N-Flatables Wacky Wiring diagram

Supplement Manual v08.13 ©2013 Great Air, Inc. dba N-Flatables
Safety Notice
All materials have been tested and comply to NFPA 701 Large Scale Test and the
California Title 19 fire rating test. This Inflatable Amusement Device complies to
the ASTM F2374-10 standards for safety, where applicable to the specific use of
this Inflatable Device. Instruction Supplement and General Installation Manuals are
included with this unit.
It is YOUR RESPONSIBILITY to read and follow these important instructions to
prevent injury for your patrons using this device!
Minimum CFM requirement for this inflatable is 810 CFM. NO Maximum CFM is
applicable.
All information included in this supplement is kept current and up-to-date. N-Flatables
reserves the right to update this information from time to time as needed.
! !
! !
* All outdoor weight containers MAY NOT comply with all state or
municipal tethering requirements for inflatable devices.
ALWAYS contact the utility company
before pounding stakes into the ground!
Cutting•Edge•Creations
2425 Enterprise Drive, Suite 600
Mendota Heights, MN 55120
Toll Free 1-800-811-7002 • Local 651-209-8600 • Fax [phone]
www.cuttingedgecreations.com
(15') Large-Sized Bouncer
Congratulations on your purchase of the
(15') Large-Sized Bouncer.
Cutting•Edge•Creations (BRAND) knows that you’ll get many hours of excitement
from your new purchase. Please read this booklet carefully, being sure
to read all of the safety precautions and the do's and don’ts of the ride.
Remember to stake (tether) your inflatable as described in the
“Installation and Setup” booklet, and be sure to have a minimum of
(1) trained operator as defined in the booklet.
Once again, we thank you for doing business with us, and call us if you
have any questions.
Sincerely,
N-Flatables / Cutting•Edge•Creations (BRAND)
The correct procedures for
installing and operating
of this inflatable unit.
• High Volume Output.................................1.0-1.5 hp; 810 CFM
This Unit Requires 1Blower(s) to Function Properly.
CEC Suggests the following Blower Types:
Recommended
Number of
Installers
Number
of
Operators
Maximum
Number of
Patrons
1 1 6
Minimum
& Maximum
Height
No. of Stakes
& Minimum
Stake Length
Indoor
Weight
Container
Anchors
75%
Buried
Outdoor
Hard-
Surface
Anchors*
Suggested Max
Weight per Patron
150 lbs.
Total Patron
Weight
900 lbs.
Use Whistle for Control
(4) 24" Long (4) 800 lbs.
34"
Min.
60"
Max.
200 lbs.
Per Container
(4) 1,600 lbs.
400 lbs.
Per Container
(15') Large-Sized
Bouncers™
1-Piece Unit includes: Entrance ramp, large zipper entrance, auxilliary
blower sleeve, tether kit, mattress reinforcement strips and carrying bag.
Recommended load: (5) patrons over 34" tall, maximum height not to
exceed 60" tall, 150 lbs. suggested maximum weight per patron.
Optional Themed panels can be used to add extra themed flavor to your
all your Large-Sized Bouncers, a perfect way to compliment your panel-
ready unit! Call 1-800-811-7002 today and ask your CEC representative
for details!
(15') LARGE-SIZED BOUNCERS
UNIT SKU# H W D/L
(15') Wacky Large-Sized Bouncer ......................................... (#B160101) ...... 12'6" x 14'6" x 17'6"
(15') Wacky Castle Large-Sized Bouncer ........................... (#B160601) ........ 16' x 14'6" x 17'6"
(15') Castle Large-Sized Bouncer .......................................... (#B160201) ........ 16' x 14'6" x 17'6"
(15') Dalmatian Large-Sized Bouncer ................................. (#B160301) ........ 17' x 14'6" x 17'6"
(15') Jungle Large-Sized Bouncer ......................................... (#B160401) ...... 12'6" x 14'6" x 17'6"
(15') Underwater Adventure Large-Sized Bouncer .........(#B120101) ........ 15' x 15' x 16'
(15') Underwater Adventure Large-Sized (w/ Shark) ......... (#B120102) ........ 26' x 15' x 16'

Static
Dimensions
(in bag)
Dynamic Dimensions
(inflated)
B = Bottom Tether
ENT = Entrance
= Evacuation
KEY TO DIAGRAM
ZIP = Deflation Zipper
EXIT = Exit
OP = Operator Position
= Blower
Locations
BL
T = Top Tether
Directions
•Read instruction booklet.
•Remove unit from storage bag.
•Position on a level ground area approximately 21' x 23'.
•Install ground stakes, at least (4) around perimeter.
•Loosely tie tethers to ground stakes.
•
Attach (1) blower(s) to tubes, making sure Velcro strap is firmly secure.
•
Close zippers & flaps on all locations of unit and make sure they are secure.
•
Connect each blower to its own power source. Keep in mind that each
blower used will require a constant supply of 110-volt, 20-amp power.
•Turn blower system on and guide the unit until it is fully inflated.
•Secure all tethers after the unit is fully inflated.
•Do a safety check of blowers, slide & climb covers.
•Do not operate this unit in winds in excess of 15 mph.
NEVER LEAVE THIS RIDE UNATTENDED!
50"
50"
50"
14'6"* 17'6"
**
Catastrophe!
This type of catastrophe can always
be avoided by proper tethering,
utilizing 24" long ground stakes, and
by having trained operators on duty
and avoiding inclement weather
(such as high winds i.e. winds in
excess of 15 m.p.h.).
Important Notice:
Specifications for Inflatable Devices may change based on reconfigura-
tions that may be required for the proper use of an inflatable device.
These changes may include, but not be limited to, the following:
1) Maximum Heights of Patrons.
2) Minimum Heights of Patrons.
3) Number of Patrons (on a device at one time).
4) Maximum Weight
5) Number Of Stakes
6) Size of Stakes
7) Number of Blowers
8) Overall physical dimensions of the device.
Any noted current changes made to any inflatable device will be updated
on our website: http://www.cuttingedgecreations.com.
OP
TOP VIEW
SIDE VIEW
ZIPPER
POSITION STAKES ABOUT
3' FROM INFLATABLE.
DIAGRAMS ARE
NOT TO SCALE.
BLOWER
EXIT
ENT
END VIEW
(15') LARGE-SIZED
BOUNCER
B
T
17'6"*
**
B
T
B
T
B
T
14'6"*
17'6"* 14'6"*
PLEASE REFER TO TETHER POINT LOCATIONS
ON THIS TETHERING DIAGRAM.
*AVERAGE DIMENSION
*AVERAGE
DIMENSION
**HEIGHT VARIES WITH
EACH UNIT.
**HEIGHT VARIES
WITH EACH UNIT.
DAILY INSPECTION
CHECKLIST OF INFLATABLE
Check to see if blower(s) is attached properly
and securely to inflatable device.
Make sure all deflation zippers are closed and secured.
Check blower electric attachment to be sure it
has been properly plugged in to receptacle.
Make sure blower system has no obstruction
restricting intake on sides of blower.
Check inflation of unit to be sure it is properly inflated to
correct firmness.
Make adjustments to slide and climb covers if necessary to
proper secure position.
Covers need to be adjusted before each use to assure that
all wrinkles are removed that could potentially cause injury.
Also it is important to inspect all covers showing signs of
wear are replaced before using this device.
Make sure all tether points are attached properly.
Check netted areas and sun covers to be sure they are in
place and in good condition.
Crawl through (if possible) inflated device and examine all
visible seams for stretching or wear. If problems with any
seams contact manufacturer to advise.
Inspect the inflatable for loose stitching causing open
seams, torn netting, worn holes in bottom or sides of unit.
If found, cease use and repair immediately using supplied
repair kit. Or if a hole or seam is open more than 1 - 2
inches, professionally repair using 207 polyester thread
from a reputable inflatable repair center.

Make sure all operators understand the proper procedures for
using this inflatable, and that passengers must follow the rules.
Deflation Rate of Inflatable:
Type of Testing: Observed
Deflation Rate to unsafe conditions: 3-5 minutes.
Buyer” (person, company or entity purchasing the inflatable product or device),
is solely responsible for the manner of use of the products and other equipment
purchased from N-Flatables. “Buyer” is solely responsible for all signage, labels
and warnings to consumers or other users of the products and equipment,
and for any and all other acts necessary, including user warnings and limita-
tions (e.g., weight, height, age, number of participants and medical condition
limitations), to ensure the safety of the users. “Buyer” acknowledges that they
have received, read and fully understand all necessary instructions for the safe
setup and operation of their Cutting Edge Creations (BRAND) inflatable product
or device. “Buyer” agrees to operate their Cutting Edge Creations (BRAND) inflat-
able product or device according to the instructions established by Cutting
Edge Creations (BRAND). “Buyer” agrees to operate their inflatable product or
device according to all state and local requirements. “Buyer” agrees to train
any person(s) operating the inflatable product or device in the safe operation
of the inflatable product or device including safe handling of emergency situa-
tions. “Buyer” shall use proper stakes, tie-downs, and other applicable devices
necessary to ensure the safety of users and the general public. “Buyer” agrees
to indemnify, defend and hold harmless N-Flatables and N-Flatables Insurers
from actions and claims of third parties, including customers of “Buyer” and
users of the goods and products sold to “Buyer”, arising out of or in connec-
tion with the use of the goods and products herein described or resulting from
the breach of the provisions in this Confirmation of Order by “Buyer”. In the
event N-Flatables is required to commence an action to enforce this provision,
“Buyer” shall pay all of N-Flatables legal costs and expenses.
Important! Use and Indemification: !!
Watch Out for High Temps!
DO NOT operate when temperatures
exceed 90-degrees. Watch for early signs
of heat exhaustion and for dehydration.
Keep Landing Areas Clear!
Operators should not allow participants
to land on one another. Accidents WILL
happen!
Instruct Safety!
Instruct riders to follow the safety rules
located on entrance side of unit. NO
flipping, as injuries may occur!
Evacuation Procedures!
The blower tube has an automatic air flap
that reduces the loss of air if the blower
system goes off. In the event of a power
outage or emergency take-down, direct
patrons off the inflatable as shown by
arrows in the diagram shown above.
Improper use of this inflatable
may cause serious injury!
Operator Take Control…
Use
Whistle!
ASTM Standard #F7324-06 6.6.1
Operators & attendants shall
incorporate the use of whistles
or other devices or signal equip-
ment & take appropriate action
at the first sign of misbehavior
or violation of posted rules.
Be sure to leave room
between you and others!
Step by Step Procedure:
Large (15') Bouncer
1. Enter the unit by crawl-
ing head first through
the entrance.
2. Once inside, start
jumping around on the
mattress. Be sure to
leave room for others.
3. Exit the unit with the
help of the operator (if
need be). Avoid Contact with Others!
Passengers must be instructed to use or
ride unit individually. Do NOT allow double-
riding, as accidents WILL happen!
Do Not Hit Your Head!
DO NOT dive or enter unit head first,
as head or neck injuries may occur!