DAKONTE DPGB 65 Series User manual

Floor Stand Partition
Parts
Components Shipped
1. Clear Partition Screen with Sewn Edges and Hanging Straps
2. Plastic Base with Wheels
3. Qty (2) Upright Poles
4. Top Cross
Bar
Assembly with Extension Tubes on Each End
Tips
Use rubber mallet or heavy book to tap Upright Poles fully into the Plastic Base.
Be sure Velcro®Strips on lower part of black Upright Poles, and Velcro strip on
Top Cross
Bar
Assembly
are
all
facing the same side
of the frame.
DAKONTE PRODUCT GROUP, INC
6615 W MILL ROAD, MILWAUKEE WISCONSIN 53218
For Assembly Assistance
or Questions
Phone
800
-
238
-
3957
Email
[e-mail]
COPYRIGHT 2020 DAKONTE Product GROUP, INC
STEP 1:
Insert Upright Poles into Plastic Base.
Push down firmly to ensure fully inserted.
Be sure Velcro® Strips on Upright Poles face
same side of the frame assembly.
Extend silver inside poles to full upright
position. Lock in place.
STEP 3:
Tip sideways to insert wheels into the base
Insert wheels with locking tabs on same side.
Assembly Instructions
STEP 1:
STEP 1:
STEP
2
:
Place Top Cross Bar onto Upright Poles.
IMPORTANT – be sure Velcro® strips on Top
Cross Bar faces same side of frame as the
Velcro strips on the Upright Poles.
Push Cross Bar down firmly to fully insert.
Lift the locking tabs on the Top Cross Bar
and slide extension tubes outward to the
line marked on the tube. Relock in place.
STEP
2
:
STEP 4:
Unroll and drape the Clear Partition Screen
over the frame, loop straps over extension
bars to hold in place. Press onto Velcro®
strips to secure in place.
STEP 4:
3" Long Hook Velcro
®
5/8" Black
Disclaimer: This partition is not intended to prevent specific diseases or
infections; provide a barrier to liquids; or provide protection from exposures or
injuries caused by physical impact, liquids, chemicals, high temperatures, dust or
debris. Individuals utilizing this partition are responsible for following all
applicable workplace regulatory requirements -including ADA accessibility.
EXCEPT WHERE SPECIFICALLY PROHIBITED BY LAW, NO WARRANTY IS PROVIDED
FOR THIS PARTITION'S FITNESS FOR A PARTICULAR PURPOSE.
DPGIP
-
37
-
14 Rev
5
STEP
2
:

Secure Clear Partition Screen using
straps and the Velcro® strips placed
on Top Cross Bar and the lower part
of the two Upright Poles.
DPGIP
-
37
-
14 Rev
5
SPARE REPLACEMENT PANELS AVAILABLE
The clear vinyl panel with sewn borders can be
ordered separately. This can serve as a "quick-
change" spare backup to keep the partition in
service while the original panel is taken off and
cleaned. Order number is similar to a complete
unit - simply add an 'S' to denote a spare panel.
Example: DPGB-xx65 is Complete Unit
DPGBS-xx65 is Panel Only
'xx' is width of unit (i.e. 34", 37", 42", 48", 53")