Daktronics Sportsound SSR-200 User manual

201 Daktronics Drive PO Box 5128 Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: [phone]
www.daktronics.com/support
Sportsound®Rack
SSR-200
Operation Manual
DD2298630 Rev 4 – 07 August 2015

DD2298630
P1534
Rev 4 – 07 August 2015
daktronics, inc.
Copyright © 2012-2015
All rights reserved. While every precaution has been taken in the preparation of this manual, the publisher assumes no
responsibility for errors or omissions. No part of this book covered by the copyrights hereon may be reproduced or copied in any
form or by any means – graphic, electronic, or mechanical, including photocopying, taping, or information storage, and retrieval
systems – without written permission of the publisher.
Sportsound®is a registered trademark of Daktronics, Inc. All other trademarks are property of their respective companies.

Table of Contents i
Table of Contents
Section 1: Introduction.......................................................................................................................................... 1
1.1 Resources............................................................................................................................................................... 1
1.2 Daktronics Nomenclature................................................................................................................................... 2
Section 2: SSR-200 Components ......................................................................................................................... 3
2.1 Overview ............................................................................................................................................................... 3
2.2 Standard Equipment............................................................................................................................................ 4
Audio Mixer................................................................................................................................................... 4
Professional CD/Media Player................................................................................................................... 4
Announcer’s Interface .................................................................................................................................. 4
Laptop Interface ............................................................................................................................................ 5
Wireless Microphone System...................................................................................................................... 5
2.3 Optional Equipment ............................................................................................................................................ 6
ADA Hearing Assist System ....................................................................................................................... 6
Wireless Personal Stereo Monitor System................................................................................................. 6
High Gain Antenna Kit ................................................................................................................................ 6
Single-Muff Headset..................................................................................................................................... 6
Self-Powered Monitor Speaker ................................................................................................................... 7
USB Audio Interface ..................................................................................................................................... 7
2.4 Signal Cables......................................................................................................................................................... 7
Section 3: Setup & Operation ............................................................................................................................... 9
3.1 Setup....................................................................................................................................................................... 9
3.2 Mixer Operation ................................................................................................................................................. 11
3.3 Wireless Mic System Operation ....................................................................................................................... 13
Wireless Receiver ........................................................................................................................................ 13
Single Receiver ..................................................................................................................................... 13
Network Receivers............................................................................................................................... 13
Wireless Mic & Bodypack Operation....................................................................................................... 14
3.4 Microphone Best Practices ................................................................................................................................ 15
3.5 Personal Monitor System Operation (Optional)............................................................................................ 15
3.6 Hearing Assist System Operation (Optional) ................................................................................................ 17
Section 4: Maintenance & Troubleshooting ...................................................................................................... 19
4.1 Maintenance........................................................................................................................................................ 19
4.2 Troubleshooting ................................................................................................................................................. 19
Section 5: Replacement Parts ............................................................................................................................ 21
5.1 SSR-200 Components......................................................................................................................................... 21
5.2 Optional Components ....................................................................................................................................... 21
Section 6: Daktronics Exchange and Repair & Return Programs .................................................................. 23
6.1 Exchange Program ............................................................................................................................................. 23
Before Contacting Daktronics ................................................................................................................... 23
6.2 Repair & Return Program ................................................................................................................................. 24
Shipping Address........................................................................................................................................ 24
6.3 Daktronics Warranty & Limitation of Liability ............................................................................................. 24

ii Table of Contents
Appendix A: Reference Drawings .......................................................................................................................... 25
Appendix B: Supplementary Manuals ................................................................................................................... 27
Appendix C: Daktronics Warranty and Limitation of Liability ............................................................................. 29

Introduction 1
Section 1: Introduction
This manual explains the operation of the Sportsound®Rack (SSR) 200. For additional information regarding
the safety, installation, operation, or service of this system, refer to the telephone numbers listed in Section 6.
This manual is not specic to a particular installation. Project-specic information takes precedence over any
other general information found in this manual.
IMPORTANT SAFEGUARDS
• Read and understand all instructions before beginning the installation process.
• Do not drop the control equipment or allow it to get wet.
• Do not disassemble control equipment or electronic controls of the system; failure to follow this
safeguard will make the warranty null and void.
• Always turn off and/or unplug the control equipment when it is not in use. This keeps equipment
protected from power spikes and lightning.
• Never yank the power cord from the outlet. Grasp the plug and pull to disconnect.
• Do not let any power cord touch hot surfaces or hang over the edge of a table that would damage or
cut the cord. Arrange the cord with care so that it will not be tripped over.
• Inspect control equipment for shipping damage such as rattles and dents, and verify that all
equipment is included as itemized on the packing slip. Immediately report any problems to
Daktronics; save all packing materials if exchange is necessary.
• Keep equipment covered when possible to protect from dust and debris.
1.1 Resources
Figure 1 illustrates a Daktronics drawing label. The drawing
number is located in the lower-right corner of a drawing. This
manual refers to drawings by listing the last set of digits and
the letter preceding them. In the example, the drawing would
be referred to as Drawing D-1007804. All references to drawing
numbers, appendices, gures, or other manuals are presented in
bold typeface. Any drawings referenced in a particular section
are listed at the beginning of it as shown below:
Reference Drawing:
System Riser Diagram ................................................................................................. Drawing D-1007804
All drawings referenced in this manual are found in Appendix A.
Daktronics identies manuals by the DD or ED number located on the cover page. For example, this manual
would be referred to as DD2298630.
Daktronics has a searchable knowledgebase of common questions and troubleshooting tips:
www.daktronics.com/support
Visit the Daktronics Support YouTube channel to learn how to properly operate Sportsound racks:
www.youtube.com/DaktronicsSupport
Drawing Number
Figure 1: Drawing Label

2 Introduction
1.2 Daktronics Nomenclature
Most display components have a white label that lists the part number (Figure 2).
Part numbers will also appear on certain drawings. If a component is not found in the
Replacement Parts List in Section 5 use the label to order a replacement. Section 6
describes the Daktronics Exchange Policy and the Repair & Return Program. Refer to
these instructions if replacing or repairing any display component.
Main Component Labels
Part Type Part Number
Individual circuit board 0P-XXXX-XXXX
Assembly; a collection of
circuit boards 0A-XXXX-XXXX
Wire or cable W-XXXX
Fuse F-XXXX
Transformer T-XXXX
Metal part M-XXX
Fabricated metal assembly 0S-XXXXXX
Specially ordered part PR-XXXXX-X
0P-1127-0024
SN: 2465
02/19/12 Rev. 1
Figure 2: Part Label
Accessory Labels
Component Label
Termination block for
power or signal cable TBXX
Grounding point EXX
Power or signal jack JXX
Power or signal plug for
the opposite jack PXX

SSR-200 Components 3
Section 2: SSR-200 Components
2.1 Overview
Reference Drawing:
Schematic/Layout; Sportsound Rack 200.....................................................................Drawing B-1190065
Figure 3 displays the various announcer’s rack components that are visible after removing the protective
covers. Refer to Drawing B-1190065 in Appendix A for rack component and connection locations as well as a
detailed wiring schematic.
# Component Reference Supplementary Manual
1Audio Mixer Section 3.2 Soundcraft EFX EPM User Guide
2Professional CD Player N/A DENON Professional CD/Media Player DN-501C
Owner’s Manual
3Wireless Receiver System Section 3.3 Shure®QLX-D®Wireless System User Guide
4ADA Hearing Assist System
(Optional)Section 3.6 Listen®LT-800, LR-400 & LA-122 Users Manuals
5Wireless Personal Stereo Monitor
System (Optional)Section 3.5 Shure®PSM®900 Personal Wireless Monitor System
User Guide
All supplementary manuals are listed in Appendix B.
Announcer’s
Interface
(Gen II)
Laptop
Interface
1
2
Rear View
3
5
4
7
6
Optional
Fiber Box
(outdoor) Wall Plate
(indoor)
OR
1
2
3
4
5
1
2
3
4
7
8
6
5
Figure 3: SSR-200 Components (covers removed, optional equipment shown)

4 SSR-200 Components
2.2 Standard Equipment
Audio Mixer
The Soundcraft EPM8 (Figure 4) features high accuracy and repeatable settings for EQ and gain controls. Mic
preamps feature high-resolution adjustment over a wide gain range of 55dB, and provide +22dB headroom
through the console. True professional 48-volt phantom power caters to condenser microphones of all types.
Unique signal monitoring watches for overload in several channel strip locations and illuminates the LED
more brightly as the signal approaches peak. Other features include:
• Eight mic/line inputs
• Two 1/4" stereo inputs
• RCA phono stereo playback inputs and record
outputs
• 3-band EQ per channel
• 2-band EQ on stereo inputs
• TRS insert sockets and inserts on all mono inputs
and mix output
• 10-segment LED output metering
• Headphone output
Professional CD/Media Player
The DN-501C (Figure 5) is a professional, rack-mount CD/Media Player with a combination of exible le
formats and comprehensive inputs and outputs. Other features include:
• Supports CD-DA/WAV/MP3/AAC/AIFF audio le formats
• USB mass storage device playback, including direct digital playback from iPod/iPhone
• Balanced analog and digital AES/EBU outputs (XLR)
• Unbalanced analog and digital coaxial outputs (RCA)
• ±16% Pitch Control
• IR, RS-232c (9-pin D-sub), and GPIO (25-pin D-sub) controllable
Announcer’s Interface
The Daktronics Announcer’s Interface (Figure 6) includes one
(1) balanced MIC output, one (1) balanced AUX input, and
headphone jacks; headphone volume control knob; and momentary
or continuous microphone activation buttons. Microphone and
headphones are provided.
Figure 4: Audio Mixer
Figure 5: Professional CD Player
Figure 6: Announcer’s Interface Kit

SSR-200 Components 5
Laptop Interface
This portable, durable balanced audio converter allows connection of a laptop
or mp3/music player into pro-level mixers (Figure 7). Other features include:
• 1/8" (3.5 mm) male input
• Balanced XLR male output
• Adjustable output volume control
• Black powder-coated aluminum chassis
Wireless Microphone System
The Shure®QLX-D® is a professional UHF wireless microphone system. Dual receivers in the audio rack
allow operation of two wireless transmitters simultaneously (Figure 8). Over 60 compatible channels per
frequency band and up to 17 compatible systems per 6 MHz TV channel are available. Automatic Frequency
Selection technology detects the clearest frequencies in the area. Other features include:
• Lockable settings
• Battery power gauges
• Effective Range: 328' (100 m) under optimal conditions
• Audio Frequency Response: 20Hz to 20kHz, ±2dB
• Total Harmonic Distortion: <0.1%
• RF Sensitivity: -97 dBm at 10-5 BER
Figure 7: Laptop Interface
Figure 8: Wireless Microphone & Bodypack Transmitter w/ Mute Switch

6 SSR-200 Components
2.3 Optional Equipment
ADA Hearing Assist System
The Listen®LT-800 Stationary Transmitter in the audio rack allows individuals to
experience every word at an event. This system is designed to broadcast the audio
signal throughout the facility. It is capable of transmitting to multiple receiver types
and its adjustable receivers allow each user to have full volume control.
The Listen LT-400 Portable FM Receiver (Figure 9) provides users with the choice
of 57 channels, a complete antenna, and accessory options ideal for a wide range of
applications. The receivers are digitally tuned so transmission will not drift, assurance
that when you select a channel it stays on the channel.
Wireless Personal Stereo Monitor System
The Shure®PSM®900 Wireless in-ear monitor system is used for on-eld/on-stage talent.
The system includes a transmitter in the audio rack and a receiver (Figure 10) worn by the
performer that allows for personal adjustment of mix and volume and compensates for
delay from the sound system.
Sound travels at 1120' (341 m) per second. This produces a noticeable delay as one moves
away from the speaker. Even experienced performers have trouble adjusting to this delay.
A wireless in-ear monitor system provides a real-time signal to the talent and blocks the
sound delay from their ears.
Note: If more receivers are required and the transmitter is already installed,
additional receiver packs and headphones are available to purchase.
High Gain Antenna Kit
The Shure®PA805 (Figure 11) is a directional antenna for increased range and
reduced interference. The “gain” of this antenna enables it to receive signals
from a greater distance than at typical “whip” type antenna. The antenna
allows for increased performance of wireless microphones with 6 db of gain.
The directional antennas may be located up to 50' (15.2 m) away from the
announcer’s rack.
Single-Muff Headset
The professional single-muff headset (Figure 12) may be used in place of the
standard announcer’s interface wired microphone and headphones. Other
features include:
• Ambient noise attenuation
• Neodymium magnet system for high reproduction precision
• Soft, circumaural ear pads
• Cardioid condenser microphone
Figure 9: Portable FM
Receiver
Figure 10: PSM
Receiver
Figure 11: Directional Antenna
Figure 12: Single-Muff
Headset