
Alpha • Omega 200
Front Panel Features
INPUT : Use this jack to connect your instrument via a standard
¼” mono cable.
ALPHA•OMEGA: The Alpha • Omega Engine is fully operational
knob. The Alpha • Omega Engine operates before the 3 band
DRIVE : This knob controls the amount of distortion that the
overdriven tones from subtle break up to overly distorted
sounds.
MOD
BLEND
BASS
content of the signal.
MIDS: +-12dB at 1kHz. This knob controls the mid content of the
signal.
TREBLE : +-12dB at 5kHz. Use this knob to change the high
content of the signal.
MASTER/MUTE : Use this knob to control the overall volume of
Rear Panel
SPEAKER OUTPUT -
Speakon or ¼” speaker cable operation.
WARNING: Do not use an instrument cable with this jack.
Using an instrument cable can damage your amplifier.
Minimum load 3Ω.
GROUND LIFT
try changing the setting of this control.
DI OUTPUT: Use this connector to send your bypass signal to
HEADPHONE OUTPUT:
the analog cabinet emulation.
AUX IN: Use this connector to play music from your laptop,
headphone output.
AC SOCKET
AC POWER ON/OFF
energy from your bass.
Warning
not open the amp.
· Never use the amp in a high moisture environment or near
liquids.
· The Alpha • Omega 200 can deliver more than 100 dB of
· Do not cover the vent holes. The fan and vent holes are part of
· Do not use an instrument cable as speaker cable. An
Specifications
Input Impedance
Load Impedance
Aux In Input Impedance
Power Output
Maximum Power Consumption
AC Input Power
Cycles
Dimensions Unpacked
Dimensions packed:
Warranty
number or for information on the nearest authorized repair
unit freight collect. Darkglass Electronics Oy is not responsible for
and repair procedures.
Darkglass® is a registered trademark of Darkglass Electronics Oy.