Datatool S4 User manual

Coding new transmitters, changing siren tones, passive arming selection
Press GREY button
Ignition
ON Ignition
OFF
Ignition
ON within
5 seconds
Ignition
ON
Ignition
OFF
LED on bike
Flashes rapidly
For 3 seconds
Press both buttons
Simultaneously within 10 seconds
Confirmation bee
p
3 seconds
To set
first digit
One beep/
flash
Ignition OFF
To set
second digit
Ignition ON
Four beeps/
flashes
Ignition OFF
To set
third digit
Ignition ON
Two beeps/
flashes
Ignition OFF
To set
fourth digit
Ignition ON
Six beeps/
flashes
Ignition OFF
1000 1400 14201426
To confirm
third digit
Ignition ON
Two beeps/
flashes
Ignition OFF
To confirm
second digit
Ignition ON
Four beeps/
flashes
Ignition OFF
To confirm
fourth digit
Ignition ON
Six beeps/
flashes
Ignition OFF
To confirm
first digit
Ignition ON
One beep/
flash
Ignition OFF
ONE LONG TONE Re
p
eat
p
rocedure to confirm new PIN
1000 1400 14201426
New PIN
1426
TWO SHORT TONES
(
3 lon
g
tones if incorrect confirmation
)
The PIN can be changed at any time by entering a new number by the above procedure
Example PIN learn
Number being learnt 1426

Coding new transmitters, changing siren tones, passive arming selection
It will not be possible to follow the procedures below without first having registered a PIN number to the alarm system
Software Switch number
Toggle to desired Switch
Press buttons as shown below
to enter desired Switch
Method of altering setting and accepting
To exit Software switches at any time turn Ignition
switch off for at least 15 seconds
Switch 1 (For customer use)
Change siren tones
Press Grey button to toggle to
switch 2 &3
(Alarm will beep once to confirm
switch number)
Grey button = Next tone
Black button = Previous tone
Switch 2 (For customer use)
Alarm arming method
(Alarm will beep twice to confirm
switch number)
Grey button/LED ON = Full passive arming
Black button/LED OFF = Passive Immobiliser
(Default)
Switch 3
(For dealer use only)
Entry to Engineer Switches
Press Black button to toggle to
switch 2 & 1
(Alarm will beep three times
to confirm switch number)
For dealer use only
For dealer use only
Press Grey button on transmitter or enter PIN number to disarm alarm
Turn Ignition switch ON, OFF, ON, OFF, ON (within 7 seconds)
Enter PIN number (after last number has been entered a long tone will be heard)
Turn ON Ignition switch then press Grey button on a new or existing transmitter
If new transmitter
-
(
The new transmitter will now have been coded to the alarm
)
Turn OFF Ignition switch (Two tones will be heard)
If only programming a new transmitter leave the ignition switch off for at least 15 seconds
To proceed to siren tone or passive arming section (Software Switches) turn Ignition back ON
Within 15 seconds of hearing these tones
Press Both buttons to save and exit back to switch selection
Press Both buttons to save and exit back to switch selection
Press
Press
To toggle between switches