Decko 136-5086 User manual

Step 1 Assembly
Tools Needed:
The side panels can be assembled to any desired
level on the racking system. Beams must be
spaced exactly 12 slots apart in order for the
panels to function properly.
Step 2 Assembly
From the top, slide one side panel (A) between the
beams and the end frames. Line up all holes with
the center of the beams. If the holes are not
in-line, the racking beams are incorrectly spaced
and will need to be re-adjusted.
Parts List
Two
Side Panels
A
Eight
Brackets
C
Sixteen Screws
Sixteen Nuts
Sixteen Washers
B
Step 3 Assembly
1. Phillips head screw driver.
2. Crescent wrench or 8mm Wrench.
Beams must be
spaced 12 slots.
Attach one bracket (C) to each of the four corners
of the side panels (A) using two screws (B) two
washer (B) and two nuts (B). Once all four brackets
are installed, tighten the brackets with a wrench
and Phillips screw driver to secure.
Repeat steps 1,2,3 to install the second side panel (A)
A
Line up holes with
center of beam
A
A
A
B
B
BC
Beam
Beam