Delco Remy AC-15 User manual

4
1
Delco Remy
2902 Enterprise Drive
www.delcoremy.com
Technical Assistance:
1-800-372-0222
AC-15 Infrared Printer
Instruction Manual
For use with all Auto Meter Hand-Held Testers
This infrared printer allows test results to be printed at a distance up to
40 feet.
2650-638

Paper
Feed Direction
2511-672
Paper
FeedDirection
2
3
CONGRATULATIONS!
You have chosen the AC-15 printer designed for use with all Auto Meter
handheld testers. If you should have any questions about this product
please refer to the contact information on the back cover of this manual.
AC-15 Infrared Printer
Thermal Paper Roll--------------------------------------------- 58 mm
AC Adapter -------------------------------- 120 VAC Output 7 VDC
Power Point Adapter for cigarette lighter socket -------------6 ft.
Printer Dimensions ------------------------- 4 1/8” W 6” D 2 1/4” H
Printer Weight------------------------------------------------------ .8 lbs
Dimensions------------------------------------- 19” W 14” D 4 3/4” H
PAPER INSTALATION
Note:
The AC Adapter is needed to
advance paper.
1. Make sure the
paper has a clean
cut. Feed the paper
into the slot as illus-
trated on the label
inside the paper com-
partment. Make sure the
paper loops under the roll
and not over.
2. Once the paper is fed squarely
press the feed button on the
printer to advance the paper through the printer.
OPERATION
The AC-15 Infrared Printer can be operated inside the carrying case or
out as long as the AC adapter is plugged in. When inside the case, note
the slots in the foam molding. These are designed to allow for receiv-
ing the signal from any Auto Meter handheld tester. Be sure there is no
obstruction that will block the I/R receiver. When the need arises as in
some eet cases take the printer to the location and use the adapter
included. It can be plugged into any available cigarette lighter socket.
1. Plug the AC adapter in and the
Red Led will light up.
2. Point the I/R receiver
that is next to the Red
LED, in the direction
of the vehicle or tester
being used.
3. Perform the test
using you Auto
Meter hand-held
tester.
4. When the test is complete,
point the tester in the general direction of the
AC-15 Infrared Printer. Press the print key on the
tester panel. The test number and results indi-
cated on the tester LCD will print
out on the AC-15 printer.
5. If the red LED on the printer
ashes, a paper jam is indi-
cated. Correct the problem
then press the “FEED”
button to reset.
The AC-15 Infrared
Printer can be oper-
ated from up to 40
ft. away.