DELLA 048-GM-48384 User manual

Congratulation on your purchase of this DELLA protable Air Conditioner.
NOTICE:
If you are missing any parts or have any questions or concerns regarding installation, please call DELLA customer service
at 1-800-863-4143.
Have this manual open and ready for reference
CUSTOMER SERVICE:
1-800-863-4143
9:00AM - 6:00PM PST (Monday - Friday)
Model# 048-GM-48384
USER’S MANUAL
14K BTU PORTABLE AIR CONDITIONER
⚠CAUTION! WARNING: Do not use this device before reading these instructions.
[email protected]
www.dellausa.com

2
When using electrical appliances, basic safety precautions should always be followed including the following:
READ ALL INSTRUCTIONS BEFORE USE
1. DO NOT shake, hit, or damage the appliance.
2. DO NOT place in outdoor or in damp
environment.
3. DO NOT use near bathtub, shower, washbowl or
swimming pool.
4. Keep unit away from direct sunlight and other
heat sources such as stove, heater, etc.
5. DO NOT spray insecticdes or any combustible
material near the unit.
6. DO NOT operate unit near ammable gases.
7. DO NOT block or cover the air inlet or vents.
8. DO NOT insert any objects or put ngers into air
inlet / outlet opening.
9. DO NOT cover the unit while it is operating.
10. DO NOT place power cord under carpet or cover
it with throw rugs or furniture. Arrange power
cord so it cannot be tripped over.
11. DO NOT run power cord over sharp edges /
corners or on any hot surface.
12. DO NOT immerse cord, plug, or the appliance in
water or other liquid.
13. DO NOT spill water or any liquid on electrical
components or connectors.
14. DO NOT touch the power plug or handling the
unit with wet hand to avoid electric shock.
15. DO NOT unplug the unit by pulling the power
cord.
16. DO NOT operate any appliance with a damaged
cord or plug or after the appliance malfunctions,
or has been dropped or damaged in any manner.
17. DO NOT use accessory attachments not
recommended or sold by the manufacturer to
prevent re, electric shock or injury.
18. Do not use this appliance near ammable gases,
liquids or other combustibles.
19. Always place appliance on a stable and level
ground surface.
20. Turn o and unplug the appliance before
assembly, disassembly, moving, or cleaning.
21. Make sure no other high current appliances
are plugged into the same circuit to prevent
overload.
22. This appliance is not intended for use by
individual (including children) with reduced
physical, sensory, or mental capabilities, or lack
of experience and knowledge unless they have
been given supervision or instruction converning
the use of appliance by a person responsible for
their safety.
23. Immediately unplug the product if the appliance
is making unusual sounds or is emitting smoke
or odor.
SAVE THESE INSTRUCTIONS
WARNING

3
USER TIPS
Portable Air conditioner is ideal for spot cooling. The compressor, condenser, and evaporator are built in a
compack unit. The air is dehumidied and cooled while a exible hose release heat outside.
Permanent installation is not necessary, This protable air conditioner is easy to move from room to room and
oers a wide range of air conditioning solution.
To ensure optimal eciency of the product, keep all doors and wondows closed when it is used as a air
conditioner or dehmidier.
Leave window open to improve air circulation when using in fan mode.
Air conditioning / dehumidifying
operation
Fan
operation
IMPORTANT:
Before installation, place the unit in a upright position for 1 hour to allow the refrigerant to settle. Air outlet
will open automatically when the unit is turned on, and closes when turned o.
Follow installation instructions to set up the unit.

4
DIAGRAM
Air Outlet
Air Filter
Air Filter
Bottom Water Drain
Upper
Water
Drain
Power Cord
Remote Control
Exhaust Hose
Window Slider Kit
Drain Hose
Exhaust Connector
Window Adapter
Exhaust
Control Panel
Handle

5
Exhaust Installation
HARDWARE ESTIMATED TIME NEEDED
1. Extend the exhaust hose and attach the connector to one end.
2. Attach the connector to the back of the unit.
The air conditioner needs to be installed next to a window and connect the exhaust hose from the unit to
the window.
INSTALLATION GUIDE
2 person assembly
15 mins

6
3. Attach the window adapter to the other end of the exhaust hose.
4. Attach the window adapter to the window slider kit.
INSTALLATION GUIDE (CONTINUE)

7
INSTALLATION GUIDE (CONTINUE)
5. Adjust the length of the window slider kit according to your window.

8
Window Kit Installation
1. Open the window sash and place the window kit horizontally on the stool / vertically against the jamb.
Adjust the length of the kit accordingly.
2. Close the window sash on the window kit.
NOTE:
Cut the window kit if the window width is shorter than the minimum length of the window kit.
*Cutting the window kit will reduce the maximum length if can extend.
INSTALLATION GUIDE (CONTINUE)
Horizontal Vertical
⚠ATTENTION: Make sure the exhaust hose is not folded as this could cause the unit to have lower
eciency or malfuction.

9
Grounding
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This product is equipped with a power
supply cord that has a three-pronged grounded plug. It must be plugged into a mating grounding type
receptacle in accordance with the National Electrical Code and applicable local codes and ordinances.
⚠CAUTION! WARNING: Improper connection of the equipment grounding conductor can result in a
risk of electric shock. Check with a qualied electrician or serviceman if you are in doubt as to whether the
product is properly grounded.
⚠CAUTION! WARNING: DO NOT modify the plug provided with the product if it does not t the outlet.
Have a proper outlet installed by a qualied electrician.
INSTALLATION GUIDE (CONTINUE)
RESET
TEST
Routinely test the integrated circuit breaker.
1. Plug the plug into a power socket. Press the“test” button and the “reset”
button should pop up.
2. Press the “reset” button to make sure the circuit breaker is engaged.

10
USER INSTRUCTION (CONTROL PANEL / REMOTE CONTROL)
POWER
Turn ON / OFF the unit.
TIMER
Set turn ON / turn OFF timer.
SLEEP
Enable / Disable sleep mode.
+ / -
Increase / decrease temperature or timer setting.
MODE
Cycle between cooling, heating, fan, dehumidifying, and fan mode.
SPEED
Toggle between fan speed.
ABCDEF
A
B
D
C
E
F
Power Control
Turn ON / OFF
Mode Control
Control mode between
Auto, Cool, Dry, Heat, Fan
°C/F
Switch between °C and °F
Auto Swing
Enable the louver to swing
automatically
Speed Control
Control fan speed
Timer Control
Enable Turn on / turn o timer
Sleep Control
Enable sleep mode
- / +
Adjusting temperature setting
/ timer setting

11
USER INSTRUCTION (OPERATING)
Power ON/ OFF
Plug the unit to a grounded socket. The display window will show the ambient temperature and turn into
stand-by mode.
Press the POWER button once to turn on the unit.
Press the POWER button again to turn o the unit.
⚠CAUTION! WARNING: DO NOT unplug the unit when it is still“ON”
Cool mode
Press the MODE button until the cool indicator is lit.
Press the FAN SPEED button to choose the fan speed.
Press the and buttons to set temperature between 60°F - 90°F / 16°C - 32°C.
Dry mode
Press the MODE button until the dry indicator is lit.
NOTE: Fan will run at low speed only in dry mode and temperature setting will be xed at 77°F / 25°C.
Heat mode
Press the MODE button until the heat indicator is lit.
Press the FAN SPEED button to choose the fan speed.
Press the and buttons to set temperature between 60°F - 90°F / 16°C - 32°C.
Fan mode
Press the MODE button until the fan indicator is lit.
Press the FAN SPEED button to choose the fan speed.

12
Turn ON Timer
Press the timer button once when the unit is in stand by mode. (Plugged into power but have not
power on)
Press and button to set your desire time.
Press the timer button again to cancel the setting.
Turn OFF Timer
Press the timer button once when the unit is running in cool or heat mode.
Press and button to set your desire time.
Press the timer button again to cancel the setting.
Sleep mode
Press buttons to enable sleep mode. The sleep indicator will lit.
The unit will run in sleep mode for 10 hours, then restore to previous status.
NOTE: Sleep mode is unavailable in fan mode.
Toggle °F/°C
Press and simultaneously and hold for 3 sec to switch between °F and °C
Auto Swing
Press the swing button on the remote control to enable auto swing.
NOTE: Auto swing is only available through remote control.
TIMER
TIMER
TIMER
TIMER
SLEEP
USER INSTRUCTION (OPERATING)

13
USER INSTRUCTION (REMOTE BATTERY)
Insert or Replace Batteries on Remote Control
Remove the cover on the back of the remote control. Replace the old batteries with two new AAA 1.5V
alkaline batteries.
Replace the cover.
NOTE: Remove the batteries if the remote control is not use for an extended period of time.
⚠CAUTION! WARNING:
DO NOT mix old and new batteries.
DO NOT mix alkaline batteries, carbon-zinc batteries, or rechargeable batteries.
All batteries should be replaced at the same time.
Remove batteries if the remote control is not used for a month or longer.
DO NOT put batteries next to or in a heat source such as re, electric heating device, etc.
Rechargeable batteries should be charged under adult supervision only.
DO NOT hit batteries against hard object.
Using the Remote Control
Point the remote control at the control panel on the unit.
The buttons on the remote control mimics the same control function as that on the control panel.

14
Condensate will residue inside the unit when operate. Water full indicator will display on the control panel
once the tank is full.
Drain the water to keep the unit working properly.
Manual Drainage
1. Unplug the unit from all power source.
2. Move the unit to a suitable drain location or place a empty container under the drain.
3. Unplug the bottom drain plug to drain water from the unit.
4. Replace the plug back on the unit once the draining is completed.
5. Restart the unit will reset the water full indicator.
NOTE: You may need to drain the unit more often if it is used in environments with higher humidity.
CARE AND MAINTENANCE (WATER DRAINAGE)

15
CARE AND MAINTENANCE (WATER DRAINAGE)
Continuous Drainage
1. Make sure the unit has been manually drained following the manual drainage instruction.
2. Move the unit to a suitable drain location.
3. Unplug the upper drain plug and insert the water drain hose.
4. Place the other end to the drain location.
NOTE: Make sure there is no leak from the hose connection.

16
CARE AND MAINTENANCE (AIR FILTER)
Cleaning the air lter
Air lter need to be cleaned to keep the air conditioner working eciently.
1. Unplug the unit from all power source.
2. Remove the lter from the unit.
3. Gentle immerse the lter in warm water.
4. Mild detergent can be added to remove dirt, particles, and pollutants.
5. Allow the lter to completely dry before placing back into the unit.
⚠CAUTION! WARNING: DO NOT operate the unit without the air lter.

17
Store your unit if not use for an extended period of time against wear and damage.
Before using the unit again.
1. Turn o and unplug the unit from all power source.
2. Drain the water tank completely following the draining instruction.
3. Clean the air lter following the cleaning instruction.
4. Remove the battery from the remote control.
5. Cover the unit with plastic sheet to protect from dust and debris.
6. Store the unit in a dry, cool place.
NOTE: make sure you store your unit in location which is not subject to extreme temperature or direct
sunlight.
1. Make sure the power cord and the unit housing are in good condition and without any crack or damage.
2. Make sure air lter and drain cap are in place.
3. Place new batteries in remote control.
4. Install the unit following the installation instruction.
CARE AND MAINTENANCE (STORAGE)

18
TROUBLESHOOTING
Problem Possible Reasons Solutions
Unit does not work
No Power Make sure the unit is plugged into
a grounded power socket
Circuit breaker triggered Check circuit breaker. Reset if
necessary
Turn on in less than 4 mins after
turninf o Wait after 4 mins
Turn ON timer enabled Cancel timer or wait until turn ON
time
Room temperature already meet
the set temperature Change the set temperature
Unit does not cool properly
Room window or door is opened The unit work best in enclose area,
close the window or door
Dirty Filter Clean the lter
Air inlet, vent or exhaust is
obstructed
Make sure nothing is obstructing
the air ow
Unusual noise level Unit is on uneven surface Place the unit on level and at
surface
Remote Control does not work
Too far away from the unit Move closer to the unit
Remote control is not pointed to
the unit receptor
Point the remote control to the
unit receptor
Low / no battery Replace with new battery

19
ERROR CODE CHART
Error Code Description Solution
P1 Water Tank Full Drain the water

20
WARRANTY
All items can be return for any reason within 60 days of purchase. Full refund will be process once item and
accessories are returned in original packaging. Full refund will be issued to the orinal payment method.
All returned items require a RA (Return Authorization) number. Which can only be provided by a DELLA
customer service representative when the return request is submitted. Item received without an RA may not
be aaccepted or may increase your return process time. Once an item has been received by DELLA, refunds
or replacements will be processed within 5 business days.
All returns must be shipped back to DELLA return center at the customer’s expense. If the reason of return
is a result of an error by DELLA, DELLA will provide a pre-paid shipping label via-email. Boxes for return will
not be provided by DELLA. Customer will be responsible to use the original boxex or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damage prior to the return.
⚠WARNING: Manufacturer and seller expressly disclaim any and all liability for personal injury, property
damage or loss, whether direct, indirect, or incidental, resulting from not following user’s manual
instruction, incorrect attachment, improper use, inadequate maintenance, or neglect of this product.
Phone or E-mail Questions
Customer Service Center
Product Assembly Returns & Refunds
Have any questions regarding your product? E-mail or call us at:
manufac[email protected]om
1-800-863-4143
FAQ