DELLA 048-IM-C8208 User manual

Model: 048-IM-C8208

Important Notices:
When using an electrical appliance basic safety precautions should always
be followed to reduce the risk of fire electric shock and/or injury including
the following:
1. Read all instructions before using.
2. Remove all packing material and carefully check your ice maker to ensure
it is in good condition and that there is no damage to the ice maker or
power cord and plug.
3. Before using the Ice maker for the first time please wait 2 hours after
positioning it and keep the transparent lid open for at least 2hours
4. Pure water is not allowed to be used on this unit spring water is
recommended.
5. Ensure the voltage is compliant with the voltage range stated on the rating
label and ensure the earthing of the socket is in good condition.
6. If the supply cord is damaged it must be replaced by the manufacturer or
its service agent or a similarly qualified person in order to avoid a hazard.
7. Do not upend this product or incline it over a 45
℃ angle.
8. To protect against risk of electric shock do not pour water on cord plug
and ventilation immerse the appliance in water or any other liquid.
9. Unplug the appliance after using or before cleaning.
10. Keep the appliance 15cm from other objects to ensure the good heat
releasing.
11. Component parts shall be replaced with like components and that
servicing shall be done by factory authorized service personnel to
minimize the risk of possible ignition due to incorrect parts or improper
service.
12. This appliance can be used by children aged from 8 years and above and
persons with reduced physical sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
Children should be supervised to ensure that they do not play with the
2

appliance.
13. Do not use the appliance close by flames hot plates or stoves.
14. Do not switch on the power button frequently (ensure 5min. interval at
least) to avoid the damage of compressor.
15. Metal sheet or other electric objects are not allowed to be inserted into the
appliance to avoid fire and short circuit.
16. Do not use outdoors.
17. Never clean with scouring powders or hard implements.
18. Please keep the instruction manual.
19. Warning: Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
20. This appliance is intended to be used in household and similar applications
such as
– staff kitchen areas in shops offices and other working environments;
– farm houses and by clients in hotels motels and other residential type
environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.
21. The refrigerant and insulation blowing gas is flammable when disposing of
the appliance do so only at an authorized waste disposal centre. Do not
expose to flame.
Is fire warning sign. Caution risk of fire.
22. Caution: Flammable refrigerant used! When handing moving and use of
the ice maker make sure to avoid either damaging the refrigerant tubing or
increasing the risk of a leak.
23. The ice maker is to be installed in accordance with the Safety Standard for
Refrigeration Systems ASHRAE 15.
24. The ice maker shall not be installed in corridors or hallways of public
buildings.
3

Specifications:
Model Number ： 048-IM-C8208
Daily Ice Output ： 15kg / 24 hours
Ice Sizes ： small 、 large
Ice Storage Capacity ： 600g
Refrigerant:R600a(30g)
N.W: 11.5kg
Water Reservoir Capacity(up) ： 2.5 L
Water Reservoir Capacity(down) ： 1.0 L
Voltage: 120V / 60 Hz
Power Consumption: 150 W
Unit Dimensions ： 357(W)X289(D)X352(H)mm
Description:
1. Rear Cover
2. Condenser
3. Top Cover
4. Water Drain
5. Evaporator
6. Transparent Water Box
7. Ice board
8. Ice Basket
9. Floater switch
10. Water Temperature Sensor
4

11. Baseboard
12. Compressor
13. Power Cord
14. Transparent Water Box Cover
15. Control Panel
Feature:
 Speedy & Regular ice-making
 Easy-use control design. Two ice sizes is optional.
 Transparent diamond ice
 Speedy (17min) and Regular (21 min) ice-making can make 24 pieces
(a board) ice
 When working status down water reservoir: 600ml
 In the status of 25 ℃， in the first time the time of making big ice is 28min
small ice is 25min. Iin the second time the time of making big ice is 21min
small ice is 17min.
5

6

7

proper position and cover it.
Step 2. Connect the power press the and then the machine enters
standby state.
Step 3. Select the desired ice size the default size of machine is large one.
Step 4. Press key to start wok.
Note: The water poured into water reservoir should e lower than the
water reservoir’s MAX position. When water volume goes eyond
the max, please open the ottom water drain plug to drain the
spare water out. Then close the transparent lid.
Note: Please select the small ice when am ient temperature is elow
20°c. When the am ient temperature is higher than 25°C, Large
ice cu e sizes are recommended.
Note: When the ice asket is full please remove the ice immediately, Do
not allow the ice Basket to overfill.
Note: When the ice asket is full enough, you can take out the up water
ox, and take out a part of ice, you can take out the ice asket.
Note: Before making ice, do put the ice asket in the ice maker.
8

9

the machine.
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
The compressor
works
abnormally with
a Buzzing
Noise
The voltage is lower
than
recommended
Stop the Ice maker and do not
restart until the voltage is
normal.
Indicator light of
lack of water
on
1.Water of Water box
is not much enough
2.The ice in water box
is full but the floater
switch is blocked
3.The floater is not
installed right
4. The floater switch is
broken
1. Add enough water toWater
box
2.Take out the ice
3.Take down the E circle on
floater switch reinstall the
floater
4.Change the floater switch
Indicator lights
on display are
not on
Blown fuse/ No power Replace fuse / Turn power on
The Ice made is
too large
and with pieces
sticking
together.
1.Water temperature is
too low
2.Ice of previous
cycles left in the water
tray
1.Select small size
2.Take out the ice under the
standby state
10

The program of
making ice is
correct but no
ice come out
1.No coolant in
compressor
2. Compressor is
damaged.
3. Fan motor is
damaged.
Call the service centre.
All indicators
twinkle
simultaneously
1.The ice is not access
to ice board
2. The movable detect
device the ice board is
damaged.
Unplug the power and plug
again to restart the machine.
The machine is
on working but
the water is
warm
Electromagnetic valve
is hitch
1.Change the electromagnetic
valve
The ice is full to
reach the ice
board but no full
indicate
1. The movable detect
device the ice board is
damaged.
2.The indicate light is
damaged
1. Change The movable detect
device or display board.
2.Call the service centre.
WARNING
If the power cord is damaged; it must be replaced by the manufacturer its
service agent or a similarly qualified person in order to avoid a hazard.
Fill with potable water only.
11

12