Delta UH4000 User manual

Assembly instructions UH4000
Single
Ball Holder
WARNING
Secure to wall by tightening both screws.
1
2
3
Hand Drill 1/8"(3mm)
Tools Required
Do not exceed maximum total weight limit of 4.5kg/10lbs.
To avoid injury, Do not overload.
Assemble unit by inserting pressed wire ends
into slots on plastic base and snap in back plate.
Identify where wooden stud lies within wall,
drill pilot holes for wood screws.
WALLBOARD
STUD
STUD
CENTERLINE
Horizontal Mounting Option

Assembly instructions HDRS4100
WARNING
Multi Ball Holder
Storage Net
Way of locating studs within the wall (see hardware store for advice)
Tools Required
Hand Drill 1/8" (3mm)
x1 — Back Plate
x2 — Wire Ends
x1 — Front Plate
x2 — Screws
x1 — Net
Parts
A
B
C
D
E
Service: Please do not return to store;
for immediate response email
[e-mail]
Assembly video
Visit designbydelta.com/downloads
Once assembled, transport to pre-drilled wall location.
Secure to wall with both screws.
1
Do not exceed maximum total weight limit of 4.5kg/10lbs.
To avoid injury, Do not overload.
Identify where wooden stud lies within wall,
drill pilot holes for wood screws.
WALLBOARD
STUD
STUD
CENTERLINE
FIGURE 1
FIGURE 2
BACK VIEW OF PLATES AND WIRE ENDS
2
After wall installation, slide net onto each arm.
3
IMPORTANT SAFETY NOTE
Beware of drilling into electrical wire
or pipes within wall!
A
B
C D E
Place front plate on the corner of a table/at surface.
Position wire ends face down into slots of front plate
Slide under small center plate. (FIGURE 1).
NOTE: Be sure front of wire ends are facing down.
Insert back plate on top. Be sure wire ends are
covered and t securely between back and front
plates. (FIGURE 2)
CORNER OF TABLE SURFACE
CORNER OF TABLE SURFACE