S&S Worldwide W4260 User manual

W4260 Mini Steel Basketball Goal with Backboard - Assembly Instructions

W4260 Mini Steel Basketball Goal with Backboard - Assembly Instructions (page 2 of 2)
Hardware Required (included)
1 - Backplate
4 – Lock Nuts
8 – Washers
4 – Screws
1. Insert the top 2 screws with a washer on them from inside of the backboard
support that is attached to the rim (image #1).
2. Holding the screws from step one in place, slide the top two holes in the backboard
(with the logo facing the rim) over the two screws just installed (image 2)
3. Slide a washer over the remaining two screws and push those from the inside of the
backboard support through the backboard (image 3).
4. Slide the backplate over the 4 screws (image 4)
5. Place a washer and then a nut over onto the screws and finger tighten.
6. Using the included allen wrench and wrench (or a screw driver fitted with a 10mm
socket head), tighten all nuts until they are secure against the backplate and there is no
wobble in the backboard (image 5).
Image #1
Image #2
Image #
3
Image #4
Image #5
S&S Worldwide ssww.com Revision – A