Denso DNNS059 User manual

6. User’s Manual Requirement
6.1. Operation Manual
(1) Registration of the Bluetooth Products
Transmits the registration signal from the Bluetooth product to the na igation system and
register the Bluetooth product at the na igation system.
(2) Selection of the Bluetooth Products
Transmits the selection signal from the na igation system to the Bluetooth product and connect
the na igation system with the Bluetooth product.
(3) Call
Call by inputting the phone number with the touch panel of the na igation system.
Get the phone by operating the touch panel of the na igation system.
Bluetooth
RF signal
Bluetooth
RF signal
Bluetooth
RF signal
Cellular
RF signal

6.2. User’s Manual Requirements of FCC rule
DNNS059 is installed in vehi le, so DNNS059 has no manual for user.
FCC user’s manual requirements that are FCC rule Part 15.21 and 15.105 are des ribed on
user’s manual of the vehi le as followings.
FCC and IC Regulation
NOTE
This device complies with part 15 of the FCC Rules and RSS-Gen.
peration is subject to the following two conditions;
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
CAUTION: Radio Frequency Radiation Exposure
This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to
ET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low
levels of RF energy that it deemed to comply without maximum permissive exposure evaluation
(MPE). But it is desirable that it should be installed and operated with at least 20cm and more
between the radiator and person’s body (excluding extremities: hands, wrists, feet and ankles).
Co-location: This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.