Designplan SPOT 1.0 User manual

+DES IGN
Pag. 1 - rev.00
NOTES:
•
Wire connections must be realized with wire nuts or
similar.
.....
1.063"
.98"
2.28"
Ø1.18" X 1.61"
SPOT 1.0 w/ AQUASTOP
Installation instructions
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042



WARNING!!!
Please read the following instructions carefully.
IMPORTANT:
•Although LED runs on a very low voltage, always cut off the power sup-
ply efore installing the LED light or su jecting it to maintenance.
•Unauthorised alterations or tampering of the product will invalidate all
the conditions of guarantee.
•
This fixture must be installed by a qualified electrician.
•
Designplan is not responsible if its fixtures are not installed in
according to local safety standards.
•
Data contained in this document may e changed at any moment with-
out prior notice.
•Use only Selv type electronic power supply or similar.
ELECTRICAL CONNECTIONS:
•LED lights run at constant current.
•LED lights must e connecte in series respecting polarities.
•
As for the choice of the power supplies, please consider the current
through which they are fed and the max power consumption of
LEDs you have to install.
•
The total num er of LEDs to e fed must e counted for each single
spot (e.g. 2 spots with 3 LEDs 1W each= 6 LEDs 1W in all= 6W).
•
The system must be fe only if all the spots are connecte . The
connection of the single spots with the power supply in voltage may
damage the spot.
•The power supplies must e installed in aerated rooms, far from heat
sources. A situation of overworking or a lack of air circulation will not
permit a natural dissipation.
•
The electronic power supply is current-sta le, therefore it partially com-
pensates the voltage-drop pro lems related to the ca le length; we
suggest not to exceed 120ft (30 metres).
•Never use switches on secondary circuit.
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
2.16" - 3.07"

+DES IGN
Pag. 2 - rev.00
1
2
220°
3
4
SCOTCH self amalgamating

Do not cut
Ac qua s to p
Ac qua s top
Ac qua s top
SPOT 1.0 w/ AQUASTOP
Installation instructions
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
WARNING!!!
LED LIGHTS MUST BE CONNECTED
IN SERIES RESPECTING POLARITIES.
THE SYSTEM MUST BE ENERGIZED ONLY AFTER ALL THE
FIXTURES ARE CONNECTED.
Series connection
PSU
Selv
POWER CONSUMPTION 1x1W; 1x2W;
SUPPLY VOLTAGE 350 - 500 mA
CONNECTION Series connections Power supply not included.
N° AND TYPE OF
LED USED 1 power LED
AVERAGE LED LIFE 75% after 50.000 hours
LED COLOURS
AVAILABLE
White: 5000K; 3000K; blue; red; green;
CRI
OPERATING
TEMPERATURE -10°C ÷ +45°C
FINISHING INOX Steel AISI 316L
WEIGHT .4 kg
APPLIANCE CLASS CLASS 2
TYPICAL LUMINOUS FLUX 85 lm/W
FIXING WP0100 accessory.
80
RESPECT POLARITY
+ = RED
- = BLUE

+DES IGN
Pag. 3 - rev.00
TERRENO
1A 2A
WARNINGS
INSTRUCTIONS FOR CORRECT WASTE DISPOSAL
Ac c ord ing to a rt. 13 o f the Leg is lative De c re e date d 25 J uly 2005 n. 151
c o nc e rning CE dire c tions o n the us e a nd dis po s a l of e le c tro nic a nd e le c -
tronic a l mate ria ls .
The symbol of the rossed rubbish skip you find on the devi e or its pa kaging indi ates
that on e the produ t had been used, it must be olle ted separately from other waste
material.
As a onsequen e, users are supposed to bring the useless devi e to the differentiated
waste disposal entres of ele troni and ele trote hni al materials. Alternatively, you an
hand it ba k to the reseller when you buy a new equivalent devi e.
The orre t differentiated waste olle tion in order to re y le the disused devi e, to treat it
and get rid of it ontributes to avoid possible bad onsequen es on the environment and
health while it favours the re-employment of the materials the devi e is made of.
The illegal waste disposal of the devi e from its holders auses the appli ation of the admin-
istrative san tions foreseen by the regulations in for e.
Non idoneo per installazioni a immersione.
Not for permanent submersion installations.
SPOT 1.0 w/ AQUASTOP
Installation instructions
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
1.53"
1.42"
10.11"