395-86861. 2
COLLAR ATTACHMENT (Optional)
NOTE
Prior to installing the collar attachment, note the
location of the Mag oilabel. Apply the magnet to
the detector housing at this location to initiate a
mag oitest. The collar attachment will cover the
label, but will not interfere with the mag oitest.
4. The Collar Attachment assembly is made up of
two halves — one installed on top, and the other
under the detector bulkhead. With the four socket
cap screws (provided) held in place with O-rings
as shown in Figure 4, place the top half in position
on the detector. Then place the bottom half under
the detector and tighten the screws using a 5 mm
hex wrench (not included). Do not fully tighten the
screws at this time.
5. Using the 5 mm hex wrench, remove the bulkhead
plug from the top half of the collar attachment and
install it in the detector bulkhead mounting hole (to
prevent corrosion). See Figure 5.
ATTACH DETECTOR TO MOUNTING ARM
6. Raise the detector to insert the large bolt on the
Mounting Arm into the detector bulkhead or the
Collar Attachment (see Figure 6).
NOTE
It is possible that two people may be needed
to complete this step, especially when dealing
with the heavier stainless steel ame detector
models.
7. Aim the detector at the area to be protected, then
use a 14 mm hex wrench to tighten the detector
mounting bolt and clevis bolts just tight enough to
hold the detector in this position. See Figure 7.
A2600
COLLAR
BOTTOM HALF
COLLAR
TOP HALF
O-RING (4X)
SOCKET CAP
SCREWS (4X)
BULKHEAD
PLUG
Figure 4–Collar Attachment Assembly, part #011385-001 shown
INSTALL PLUG IN
BULKHEAD MOUNTING HOLE
A2603
Figure 5–Correct Installation of Collar Attachment to Detector
A2601
Figure 6– Connecting a Detector with Collar Attachment
to Mounting Arm
Figure 3— Q9033 Mounting Arm with Collar Attachment
Dimensions in Inches (cm)
A2604
NOTE: THIS ILLUSTRATION SHOWS THE
DETECTOR MOUNTED AT THE 10° MINIMUM.
THESE DIMENSIONS WILL CHANGE BASED
ON THE DETECTOR’S MOUNTING ANGLE.
(28.5)
10.6
(27.0)
2.63
(6.68)
2.0
(5.08)
6.5
(16.5)
NOTENOTE
Socket cap screws enter from the bottom in part
#011385-002.
