Dimplex DXLOLA User manual



ContactDetails

Pleasenotethatsomeofthecontactdetailson
thisPDFdocumentmaynotbecurrent.

Pleaseusethefollowingdetailsifyouneedto
contactus:

Telephone:08448793588
Email:[email protected]


Thecustomersupportsectionofourwebsitealsofeaturesawide
rangeofinformationwhichmaybeofusetoyouandisavailable
24hoursaday.Itincludes:

•Operatingandinstallationinstructions
•Easy‘Howtouse’guidesforstorageheaters
•Serviceandrepairs
•Wheretobuyourproducts
•Literaturedownloads
•Heatingrequirementcalculator

Visit‐www.dimplex.co.uk/support
A division of GDC Group Ltd
Millbrook House Grange Drive Hedge End Southampton SO30 2DF
www.dimplex.co.uk
Re
g
istered No: 1313016 En
g
land
VAT GB 287 1315 50004
EEE Producer Registration Number –
WEE/GE0057TS
Paper from sustainable sources

DXLOLA
Humidifier/Aroma Diffuser
with Harmony-Lighting
Maintain a balanced level of
room humidity, whilst relaxing to
the fragrance of your favourite
scented oil in harmonious light
conditions.
1.External mist chimney
2.External housing
3.Internal mist Chimney
4.Water tank
5.Base
6.Water reservoir
7.Power adaptor
8.Ultrasonic transducer
9.Harmony-Lighting
system
10.Operation controller
11.Power on/off
12.Harmony-Lighting
pattern control
13.Water tank sensor
14.Power connector
15.Finger handle
FEATURES & BENEFITS
Stylish design integrates seamlessly with your living environment.
Moisturises the air and balances room humidity using ultrasonic technology.
Helps to alleviate the effects dry air can have on the body such as; itchy/dry
skin, chapped lips, sore throat.
Can assist breathing for asthma, allergy and cold sufferers.
Fragrance your room by adding a few drops of your favourite scented oil to
the water reservoir.
Create a calm and relaxing ambience by activating the Harmony-Light
system.
3 misting levels for your comfort
6 hours of continuous whisper-quiet operation
Auto shut-off when water tank empties
Easy to operate and clean
Use and store the product in a dry place. Avoid positioning in areas
where the product could be submerged in water.
If product falls over, disconnect from the mains power supply
immediately
After use, disconnect the power connector and carefully pour out any
remaining water resting in the water reservoir
Do not operate product in reach of children
Unplug from the mains power supply before filling the water tank and
before placing in position for operation.
DO NOT operate the mist function without water. Ensure the product
is switched off when the water tank has emptied.
DO NOT fill the water reservoir directly from the tap
DO NOT fill the water tank with any liquid other than water, (i.e.
chemical or corrosive fluid as this can cause damage to the product.)
DO NOT put scented oils directly into the water tank as this can
damage the product. When using scented oils 2-3 drops should be
added to the water reservoir.
DO NOT remove the external housing or internal mist chimney when
product is in operation.
DO NOT touch the ultrasonic transducer when the product is in
operation.
DO NOT immerse the product in water or any other liquid
DO NOT use distilled or iced water in the product,
For efficiency we recommend that pure filtered water is used in this
product as opposed to tap water.
When using the product ensure it is placed on a flat surface
Ensure the product is disconnected from the mains supply before
moving or cleaning
If the product develops a fault inside the warranty period do not use.
Contact the retailer where you purchased the product or the
manufacturer.
To detach the external housing, place product on a flat
surface, hold onto the finger handle and twist the
housing in an anti-clockwise direction then lift off. (Fig 1)
To re-attach the external housing, align the dots visible
on both the base and the external housing. Place the
housing into position and twist in a clockwise direction
until you hear or feel a click. (Fig. 2a, Fig. 2b & Fig. 3)
Start Up
Detach the external housing and remove the water tank
(Fig. 4)
Unscrew the stopper on the bottom/underneath of the
water tank (Fig. 5a), and fill with water until the level is
just below the bottle neck (approx 300ml) (Fig. 5b)
DO NOT overfill as this may cause the product to not
work effectively.
Never add water directly to the water reservoir (Fig. 6a)
To remove water from the water reservoir, pour out as
detailed in Fig. 6b
When using scented oils, add 2-3 drops to the water
eservoir DO NOT add directly to the water tank or onto
the ultrasonic transducer
Place water tank firmly back in place over the water
reservoir (Fig. 7)
Re-attach the external housing as directed
Connecting the Power
To connect the product to a power source you must first connect the power
connector to the operation controller (Fig. 8) and then plug in to the mains
socket. Once connected to a power supply a blue light on the operation
controller will illuminate above the small button (Fig. 8)
When disconnecting ensure the blue light has switched off before
disconnecting the power connector from the operation controller.
Controlling the Mist Levels
Using the Operation Controller:
To turn the product ON, press and hold the larger of the two buttons on the
power controller (Power on/off) for one second then release.
Use the larger button to control the three misting levels. Each time the larger
button is pressed and released, the mist level will change by way of a step
sequence series (High/Med/Low).
To turn the product OFF, press and hold the larger of the two buttons on the
power controller (Power on/off) for one second then release.
The mist intensity can also be controlled by rotating the nozzle at the top of the
mist chimney.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
USE AND STORE IN A SAFE PLACE FOR FUTURE
REFERENCE.
WARNING
This appliance is not intended for use by children or other persons
without assistance or supervision if their physical sensory or mental
capabilities prevent them from using it safely. Children should be
supervised to ensure that they do not play with the appliance.
Please ensure you read all instructions
thoroughly before using the product.
IMPORTANT SAFETY INSTRUCTIONS
OPERATING INSTRUCTIONS

Recycling:
After Sales Service:
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product
free of charge provided it has been installed and operated in accor-
dance with these instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee. Should you
require after sales information or assistance with this product please
go to www.gdcgroup.co.uk or ring our helpdesk on 0845 604 2330
(UK) or 01 842 4833 (R.O.I.).
Please retain your receipt as proof of purchase.
CE This appliance operates at DC24V complies with the definition of
a Safety Extra Low Voltage appliance under European Appliance
Safety Standard EN60335, it complies with European Electromagnetic
Capability (EMC) EN55014-1, EN55014-2, EN61000-3-2 and
EN61000-3-3 which cover the essential requirements of EEC Direc-
tives 89/336/EEC and 93/68/EEC. The power adaptor also complies
with EN60950-1/A11:2009, EN61558-1/A1:2009 and EN61558-2-
16:2009.
Dimplex Customer Service UK:0845 600 5111
Milbrook House Fax: [phone]
Grange Drive Email:
[email protected]
Hedge End Republic of Ireland:01 842 4833
Southampton
S030 2DF
A division of GDC Group Ltd. Website: www.gdcgroup.co.uk
© GDC Group Ltd.
All rights reserved. Material contained in this publication may not be
reproduced in whole or in part without prior permission in writing of
GDC Group Ltd.
This marking indicates that this product should not be
disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please recycle this
product responsibly to promote the sustainable re-use of
material resources. To recycle your used product contact the
retailer where the product was purchased or use your local
authority recycling facilities where these exist.
Operating the Harmony-Lighting System
To operate the Harmony-Lighting system, press and release the smaller of
the two buttons (Harmony-Lighting pattern control). The light pattern will
change by way of a step sequence series each time the button is pressed
(Intermittent/Continuous/Off).
NOTE: If desired, the ‘Harmony-Lighting System’ can also be operated
independently of the mist operation.
Operation Time
When the water tank is filled to its full capacity (approx 300ml), the normal
operation time when set at high mist is approx 6 hours.
When the misting level is set at medium or low the product will automatically
stop operating after 6 hours.
IN THE INTEREST OF SAFETY: Should the water tank empty before the 6
hour operating time passes (as a result of relative low humidity or tempera-
ture), the product will automatically switch off.
To maintain optimum performance it is recommended that after 6 hours of
use the product is rested and left unused for 30 mins.
CAUTION:
Only operate the product once the external housing is in place. Failure to
do so may result in the water entering parts which could cause damage to
the product.
Do not move the product when it is switched on. Should you wish to
relocate the product, switch it off, disconnect the power controller and
empty the water reservoir (as detailed in Fig. 6b)
Should water get into the base of the product, DO NOT USE. Leave to dry
thoroughly before using again.
Avoid dropping scented oils onto any part of the base of the product (except
the water reservoir). If this happens wipe off immediately with a damp cloth.
Cleaning and Maintenance
ALWAYS SWITCH THE PRODUCT OFF AND DISCONNECT FROM
THE MAINS PRIOR TO UNDERTAKING ANY CLEANING OR
MAINTENANCE
After use switch off the product and unplug from the mains. Empty the
water reservoir and the water tank and leave to dry thoroughly before
storage.
No part of this product can be cleaned in a dishwasher.
Do not use detergents, soap, cleaning fluids, abrasives, glass or furniture polish
to clean any part of this product as doing so may damage the surfaces and
interfere with its proper operation.
Do not use sharp or metal objects to clean any part of this product.
To clean the water reservoir after using scented oils, empty and wipe with a soft
damp cloth then leave to dry thoroughly.
Should mineral deposits occur in your water bottle put a small amount of
white vinegar mixed with water into the bottle and allow to soak for 30
minutes, this may help to remove them, then shake and rinse out completely
before using again.
To clean the external housing gently wipe with a damp cloth and leave to dry.
You must regularly clean the metal part of the ultrasonic transducer and the
water shortage protection sensor regularly otherwise the product will stop
producing mist & will not function correctly! This should only be done by
taking a cotton bud soaked in sanitary alcohol and gently wiping clean the
metal surface of the transducer and the protection sensor (Fig. 10). NB
please take care not to drop sanitary alcohol on the casing surface as this
may attack and remove the paint, if you do touch or drop some then wipe it
off immediately with a damp cloth.
After long periods of storage we recommend that you clean the product
before use.
Store in a dry place.
Safe Use of Scented Oils
Wash hands immediately after use
Keep oils away from naked flames
Keep oils away from children
DO NOT drink scented oils. In the event of this occurring, consult a doctor
immediately
Avoid contact with eyes. In the event of this occurring, bathe the affected eye
with cold fresh water and consult a doctor.
If you are pregnant consult a doctor before using any scented oils. Some
essential and aromatherapy oils can induce premature labour.