DIRECT OUTDOOR LIVING GENEVA User manual

1

B
GENEVA (SINGLE CHAIR)
ASSEMBLY INSTRUCTIONS
CHECK THAT YOU HAVE ALL THE
PIECES LISTED ON THE LEFT HAND
SIDE.
LAY A CLEAN SHEET ON A FLAT
SURFACE BIG ENOUGH TO ASSEMBLE
YOUR FURNITURE ON IN ORDER TO
PROTECT YOUR FURNITURE.
A 1
1
C 6
D6
E 1
F1
GENEVA SINGLE CHAIR ASSEMBLY INSTRUCTIONS . DIRECT OUTDOOR LIVING
1.
Lay the chair back (A) down with the bolt brackets facing upwards. Then
attach the chair base (B) by aligning the bolt brackets with those of the chair
back (A), inserting bolt (E) through both brackets and then placing a nut (D)
over the bolt to secure the bolt in place. Loosely tighten the bolts using the
spanner (F) and the allen key (E) as you go. Once all of the bolts and nuts have
been put in place fully tighten them all.
BEFORE YOU START ASSEMBLING YOUR
FURNITURE:

B
GENEVA (THREE SEATER SOFA)
ASSEMBLY INSTRUCTIONS
CHECK THAT YOU HAVE ALL THE
PIECES LISTED ON THE LEFT HAND
SIDE.
LAY A CLEAN SHEET ON A FLAT
SURFACE BIG ENOUGH TO ASSEMBLE
YOUR FURNITURE ON IN ORDER TO
PROTECT YOUR FURNITURE.
A 1
1
C 1
D 1
E 14
FF
GENEVA SOFA ASSEMBLY INSTRUCTIONS . DIRECT OUTDOOR LIVING
1.
Attach the sofa base (C) to the left sofa side (A). Do this by aligning the bolt
brackets and placing bolt (E) through the holes and then through a nut (F) to
secure the bolt in place. Then loosely tighten using the allen key (G) and the
spanner (H). Repeat this process and attach right sofa side (B) to sofa base
(C).
Then attach (C, A & B) to the chair back (D). Lie your sofa back (D) down with
the bolt brackets facing upwards. Again, align the bolt brackets together as
shown in the above image. Then place bolt (E) through both the brackets
and then through a nut (F) to secure. Fully tighten all of the bolts to complete
the assembly using the allen key (G) and spanner (H).
G1
H1
14
BEFORE YOU START ASSEMBLING YOUR
FURNITURE:

B
GENEVA (TABLE)
ASSEMBLY INSTRUCTIONS
CHECK THAT YOU HAVE ALL THE
PIECES LISTED ON THE LEFT HAND
SIDE.
LAY A CLEAN SHEET ON A FLAT
SURFACE BIG ENOUGH TO ASSEMBLE
YOUR FURNITURE ON IN ORDER TO
PROTECT YOUR FURNITURE.
A 1
1
C 1
D 4
E 4
GENEVA TABLE ASSEMBLY INSTRUCTIONS . DIRECT OUTDOOR LIVING
1.
Attach table feet (D) to the table (A). Align the table feet (B) in the locations
shown in the above image and insert two screws (F) through the feet (B) (do
not insert them into the hole in the corner of the foot) and into the table base
(A). Tighten the screws with the allen key (G). Then screw in part (E) into the
middle hole of (D).
Part (E) allows you to alter the height of each leg on the chair to allow for
uneven ground below the sofa set. You can alter each leg to a different
height to suit the location the table is placed.
M6*30
2.
Place the table upright, insert the ice bucket (C) into the middle hole and
cover with the ice bucket cover (B). Then place the tempered glass table top
(H) over the table (A).
G
F
H
8
1
1
BEFORE YOU START ASSEMBLING YOUR
FURNITURE: