Display Sales Spade Mount Decoration User manual

Spade Mount Decoration
Installation Instructions
Thank you for investing in a Display Sales Spade Mount decoration! We hope your experience is a
positive one when working with our decor during your preparation for the upcoming holiday season.
Please call 800-328-6195 should you have any questions, concerns, or troubles. Thanks again!
DISPLAY
SALES
Storage Tips: (Proper care of your decorations will ensure years of enjoyment!)
•Store decorations in a dry, well ventilated area where the heat does not exceed 105°.
•Reuse the shipping cartons, hang decorations from large hooks in the ceiling, or use
heavy-duty brackets on the wall. Cover with paper or cotton sheeting to protect while
in storage.
•DO NOT STACK DECORATIONS ON TOP OF EACH OTHER!
•Wash your decorations every 2 or 3 years. Wash every year if your area has a lot of dust,
exhaust, or pollution; uses road salt; or if you’re located in a coastal environment.
Tools Needed:
•Flat blade screwdriver (to tighten banding)
•Duct tape (to hold bracket onto pole if working alone)
•A bucket truck or ladder (to reach the height at which you wish to install the decoration
For replacement bulbs call: 1-800-328-6195
(Step by step instructions on the following page)

Installation Instructions for Spade Mount:
Check contents of box. There will be 2 adjustable banding straps per spade mount bracket.
STEP 1: Place the top of the spade mount at the desired height. This varies depending on the size of the
decoration, the size of the light pole, and vehicle and/or pedestrian trafc. Clearance should ideally be 2 feet
above truck or pedestrian trafc.
STEP 2: Insert the top band through the slots in the spade mount. Bring the end around the pole and through
the screw lock. Push screw down so threads of screw engages the slots in the band.
STEP 3: Using a screwdriver or a wrench, slightly tighten the band so spade mount is held in place rmly, but
not so much that it lifts the bottom part of the hardware off of the pole.
STEP 4: Install the other band as above. Slide both bands around the pole so the loose ends can be put
inside the slots of the spade mount if possible. Tighten both bands until spade mount is very rmly against
the pole.
STEP 5: Take the decoration and insert the spade portion into the track of the spade mount.
STEP 6: Connect the male lead cord into your electrical supply.
TO ENSURE WARRANTY OF DECORATIONS PLEASE USE BOTH BANDS!
Spade Mount
without bands
Spade Mount
with bands inserted
Step 5
(inserting spade portion of
decoration into track of
the spade mount)
Spade Mount
on pole
Spade Portion
of Decoration