Setting RGB / Indicator Segment Animation State
By sending MIDI message of a particular value it is also possible to set a variety of animation
states for each ring, these animations modify the current color state of the ring illumination.
The available animation states are,
RGB Strobe | Value 1 - 8
Allows the user to gate (flash) the current color at one of 8 different rates. If a MIDI clock
signal is present the timing is derived from that, otherwise the timing is based on a half
second interval which is the equivalent of 120 BPM. This is useful for creating warnings,
for example in Traktor you could map the Track End Warning output to flash an LED when
the track is nearing its end.
RGB Pulse | Value 9 - 16
Similar to the Gate animation this allows the user to pulse the current color at one of 7
different rates. If a MIDI clock is present the timing is derived from that otherwise the
timing is based on a half second interval which is the equivalent of 120 BPM. This
animation is useful for creating subtle alerts, for example in Traktor you could map the
Loop On output to control the pulse rate to reflect that the loop is active, and what length
it is set to.
RGB Brightness 17-47
Allows the user to control the brightness of the RGB LEDs. Very useful to give or take
emphasis from a parameter. I.e. showing a parameter in a off state while color is still
visible or VU meters.
Indicator Strobe | Value 49 - 56
Allows the user to gate (flash) the current color at one of 8 different rates. If a MIDI clock
signal is present the timing is derived from that, otherwise the timing is based on a half
second interval which is the equivalent of 120 BPM. This is useful for creating warnings,
for example in Traktor you could map the Track End Warning output to flash an LED when
the track is nearing its end.
Indicator Pulse | Value 57 - 64
Similar to the Gate animation this allows the user to pulse the current color at one of 8
different rates. If a MIDI clock is present the timing is derived from that otherwise the
timing is based on a half second interval which is the equivalent of 120 BPM. This
animation is useful for creating subtle alerts, for example in Traktor you could map the
Loop On output to control the pulse rate to reflect that the loop is active, and what length
it is set to.
