Dream Vision R9852062 User manual
CEILING MOUNT ASSEMBLY INSTRUCTIONS
R9852062 - DreamBee ceiling mount
Date: 20012007 Part. No.: R699742Rev: 01
www.dreamvision.net
Assembly Instructions:
This product is designed to be used in private homes.
Correct assembly is essential for the long life and functionality of your ceiling mount.
Please observe the following points carefully.
Technical data:
-WxDxH: 340mm x 270mm x 95mm.
-Maximum load: 50 Kg.
-Net weight: 2.2 Kg.
-Adjustable 14° up and down.
-Auto-secured hook system.
Notes on safety:
-The mount is intended for fixing to the ceiling only.
-Before attaching the base to the mount check it thoroughly for any damage.
-Never use defective parts.
Please observe the following before assembly:
-It is expressly recommended to have installation carried out by a specialist.
-Make sure that the quality of the ceiling is sufficient to hold the weight of the projector
plus that of the mount. If there is any doubt regarding the condition and load of the ceiling,
please consult a specialist from building trade.
-The fixing materials must be suitable for the type of wall so that the maximum load can be
guaranteed. For this reason no fixing materials have been included with the ceiling mount.
Please check a specialist, giving the relevant details.
-Also make sure that there are no electricity cables or gas/water pipes in the ceiling.
-Before assembling, check the location of the nearest main socket.
Assembly:
1) Mounting the ceiling plate
-Assemble the flat plate (item 1) with the ceiling support (item 2) as described in fig. A.
-Align the support (item 2) perpendicularly to the screen before tightening the fixing wing
nut (item6)
-Assemble the two round head screws (item 5) with the ceiling support (fig. B).
2) Positioning the ceiling plate
-Use the flat ceiling plate as a template to mark the drill holes on the ceiling (fig. C)
-Make sure that the plate is mounted firmly to the ceiling.
3) Mounting the projector plate
-Place the projector mounting plate (item 3) against the projector and screw the four bolts
8 x 30 mm (item 4) firmly (fig. D)
4) Attaching the projector to the ceiling plate
-Align the hook-shaped mount with the ceiling plate and verify that the lock washers are
not tightened (fig. E)
-Hook the projector to the ceiling plate and adjust the projector to the desired angle before
tightening the safety round head screws (fig. F)
NB: DreamVision accepts no liability for damages caused by incorrect assembly or
by improper use.
Item No. Part name Designation QTY
1 Flat ceiling plate 1
2 Ceiling support 1
3 Projector plate 1
4 Bolt M8x30 4
5 Round head screw 4
6 Wing nut diam. 8 1
7 Flat washer diam. 8 4
8 Flat washer diam. 7 2
9 Flat washer diam. 6 4
10 Lock washer large 5
11 Lock washer medium 4
340 mm
130 mm
95 mm
270 mm
130 mm
A
1
2
8
6
10
B
5
11
9
C
Ceiling
D
Projector
7
4
10
3
E
F
Contact information
TEC - DreamVision
7, rue La Caille, 75017 Paris, France
Tel +33 1 42 29 44 44
Email sales@dreamvision
www.dreamvision.net
Part. No. R699742 - Jan ‘07
