dreo DR-HHM003 User manual

DREO
Cool & Warm Mist
Humidifier
USER MANUAL

Thanks for
Choosing
DREO!
Your support means the world to us. We
hope you enjoy our product as much as
we did creating it

CONTENTS
01 02
IMPORTANT SAFETY KNOWING YOUR
INSTRUCTIONS HUMIDIFIER
1 3
USING YOUR HUMIDIFIER CLEANING AND
MAINTENANCE
7 12
TROUBLESHOOTING DREO CUSTOMER
CARE
19 20

IMPORTANT SAFETY 0 1
INSTRUCTIONS
READ AND SAVE THESE
INSTRUCTIONS
JAN
DANGER y
READ ALL CAUTIONARY -
MARKINGSONTHE ~ DONOT ~ DONOT ~ DONOT
APPLIANCE AND touchorhold block or let children
themains coverthe orpetsplay
SAFETYINSTRUCTIONS ),,q withwet nozzle while with this
INTHEUSERMANUAL hands in operation. appliance.
BEFORE USE.
General Safety
Children shallnot play with the sppliance. Cleaning and maintenance shallnot be
performed by children without supervision.
Use the appliance as descrived in the user manual ony. Any other use not recommended
inthe user manual may cause fire. electrical shock.or personal nury.
This appliance can be used by children aged above 8 years and persons with reduced
physical, sensory or mental capabilties orlack of experience and knowledge ifthey have
been given supenvsion orinstruction concerning use of this appliance in a safe way and
understand the hazerds involved
»
Operation Safety
Aways place this appliance on a firm, fat and level surface to avoid dropping o it
Always place this appliance 2 feet (60 cm) above the fioor, 12 inches (30 cm) away from
the wallor wooden furiture.
DONOT move this appliance whiletis on.
4. DONOT attempt to repair any parts on this appliance. Doing sowillvoid your warranty. The
inside ofthis appliance contains no user serviceable parts. All servicing shouid be:
performed by qualfied personnel oly.
o

Electricity Safety
Make sure that the voltage of your electricity supply s the same as that Indicated on the
appliance.
Aways unplug before cleaning or leaving the appliance unused for a long period of time:
Keep your hands dry when plugging/unplugging
To avold fire hazard, NEVER put the cord under rugs, near heat registers, radiator, stoves
orheaters
Donotuse this applance f the cord has been damaged to avoid ire or eectric hazard.
Keep the cord out of heavy traffic areas and where it will not be tripped over.
Do ot operate any humidiier with'a damaged cord or plug. Discard the appliance or
return to an authorized sevice faciity for examination and/or repai.
Donot run cord under carpeting Donot cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic
area and where it wil not be tripped over.
WARNING: To reduce the risk offre or eleciric shock, do not use this humidifier it any
solid-state speed control device.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk.
of slectric shock.this plug s intended to fit ina polarized outlet only one way, I the plug
Goesnot it fullyin the outlet, reverse the plug. it stil does not it contact a qualified
electrician. Donot attempt to defeat this safety feature.
FOR HOUSEHOLD USE ONLY
Gentle Reminder Specifications
Model DR-HHMOO3
Check the appliance regularly
and refer to
@) ORS00 orcontact et ACT20VE0Hz
ourcustomer supportifit
=" shows any ofthe following Rated Power 20u(Coo)
signs 280W (Warm)
Water Tank Capaci
- Power cord or plugis damaged, iy |G
- Loud noise, unusual smell or excessive 300 mifh (cool mist)
heat. Maximum Mist Output
500 mih (warm mist)

KNOWING YOUR
HUMIDIFIER 0 2
Package Contents

Mist Tube:
AromaPad Tray.
Hot/cold mist
Power & Plug mixer
Noise Silencer
Absorption Pad
PTCHeater
User User Manual / Cleaning Brush
Nanua
AromaPad X3
Quickstart Guige D @ @ (2Pre-istalied)

LED Display
5 10
-88.
oy | —
Cool (Blue) / Warm (Orange) Low Water
Mist Level Indicator Level Indicator
€]
o
%
Humidity Level / Mist Level palmICIt
I Timer Hour Tndicator
Warm Mist
Note:
When humidity levels are below 10%, the display will show *LO",
When humidity levels are above 90%, the display will show “HI'
When the water is low, the Low Water Level Indicator will flash for 5 seconds then
the humidifier will switch to standby.
Control Panel
Turn the humidifier on/off.
O Power Button Long Press for 10 seconds torestore to
factory settings.
Switch between Low/Medium/High
fi
Mist
Level
Button
mist
level

@ Auto Mode Button
995 Warm Mist Button
@ Sleep Mode Button
@ Timer Button
Turn Auto Mode on
Touch the Auto Mode button to ncrease the
target humicity by 5%, (Target humidity ranges.
from 30%t080%)
In Auto Mode, mist level is adjusted according to
Your target humidity.
Turn warm mist off/on
Note: The warm mist is turned on by defaut.
Turn Sleep Mode on
InSleep Mode, the humidifier will switch to low mist
Warm mist and ambient light willbe tured off.
Select to set a timer (0-12.)
Whenthe timer is tumed off, the LED screen will
display “OH"
Humidity Indicator Light
Humidity Light Color | Humidity Level
Yellow =30%
Green 31% - 60%
Blue =61%
The LED indicator will change according to your room humidity level.

USING YOUR
HUMIDIFIER 03
Before Use
When using your humidifier for the first time, remove the wraps and follow the
steps below
@
Detach the cover and water tank
from the humidifier and clean
thoroughly.
Make sure the water filter is
installed correctly and the
yellow label has been removed.
Fill the tank with water, making
sure the water doesn't pass the
MAX line.
Put the water tank backin
place and close the top cover.

, ® Placethe humidifer ona fat, level
= surface, keeping at least 30 cm /12
Bioen inch away from walls or any major
obstacles
ATTENTION:
Itis recommended to add purified or distilled water to prevent white
powder residue from forming
Do not add essential ol into the water tank to avoid damage to the tank.
Do not place the humidifier on the carpet or floor directly.
Direct the mist away from walls, furniture and electrical appliances.
Itis recommended to place a water-resistant mat under the humidifier
to catch spills and droplets
General Operations
Plug the humidifier into an electrical outlet
Touch O toturn on/off the humidifier.
Touch 3% to switch between Low, Medium and High mist settings
Cool/Warm Mist Level Indicator
Mist Level BIEEEy
Low J—
Medium —_—
High [R——
The indicator is blue in cold mist mode and turns orange in warm mist mode.

360°
@ Adjustthe direction of the
mist with the 360° rotating
nozzle.
Warm Mist
Touch 3% totur onfoff warm mist
Mist Level Mist Temperature (+2-3°F)
Low N3°F
Medium 124°F
High 133°F
/N cauTion:
Mist may be hot in warm mist mode. Do not place your bare hands, face,
or other exposed skin over the nozzles while using warm mist
Auto Mode
In Auto Mode, mist level is adjusted according to your target humidity.
« Touchthe @ button to turn on Auto Mode
« Touchthe (&) button to increase the target humidity by 5% (target
humidity ranges from 30% to 80%.)
Timer
« Touch the (O button to select a timer (0-12n)
« When the timer is turned off, the LED screen will display “OH"
Sleep Mode
« Touchthe (, button to enter Sleep Mode. In Sleep Mode, the humidifier
will switch to low mist. Warm mist and ambient light will be turned off

« Sleep Mode automatically turns off warm mist to reduce noise levels.
Touchthe %3 button to turn on warm mist in Sleep mode.
« Touchthe § button or the {&) button to exit Sleep Mode.
Adding Essential Oil
@ Pushtoopen the aroma pad tray.
@ Openthe lidonthe side you want to
add the essential oil.
@ Add5-10drops of essential ol on
the aroma pad.
@ Putthe aroma pad tray backin
place

Note:
+ Add essential oils on the aroma pad only. Do not add into the water
tank or any other places.
« The scent may be soft, this humidifier is not intended to work as an
aroma diffuser.
* The scent evel cannot be adjusted
« The tray contains two separate compartments. Leave open the
compartment that has the scent you like.
« If the aroma pad becomes too stiff, it needs to be replaced.
Absorption Pads
The mineral absorption pads help reduce mineral
buildup (scale) inside the humidifier, especially
on the heating element,
”‘% The absorption pads shall be cleaned
/j and replaced regularly.

CLEANING AND
MAINTENANCE
‘Always tun off and UNPLUG the humidifier before any cleaning or
maintenance.
Donot clean the main body under running water.
Donot et water splashintothe air outlets
Donot use any chemical agents when cleaning the humidifier.
Storeina cool, dry place and cover it to protect from dust.
Donot overfill the humidifier due to the potential risk of efectric shock.
Filling & Refilling
o) @ (fi
7
Detach the water tank from the Remove the mist tube and rinse
base. it with warm water.
Take outthe water tank cover, drain any
remainingwater fromthe tankandthebase. Rinse the tank with warm
Note: fyou've used the warm mist setting, water
usecautionin case the water is stil hot.

Gently clean the base with a soft Wipe the tank clean with a soft,
cloth or the included cleaning brush. damp cloth.
Fill the tank with room-temperature Attach the mist tube to the back of
‘water. Do not fill with hot water. the base.
©
-
Attach the water tank to the base,
replace the top cover.

Descaling
RECOMMENDED ONCE AMONTH
(0]
Drainany remaining water from the Fillthe tank ith a solution of bieach
tankand the base. and water (one teaspoon of bleach
foreach gallon of water ). Replace the
tank cover and shake around the tank
® 2]
Attach the water tank to the base. Remove the water filter.
Letitsit for 16-20 minutes.

Remove the mist nozzle, mist tube,
hot/cold mist mixer, noise silencer
andfioat.
Remove the tank and detach the cover,
drain any remaining solution from the.
tankand the base. Rinse the tank with
water untilthe bleach smell is gone.
Place the parts above in a small
container, fillwith a solution of 50%
vinegar and 50% water. Soak for 15-20
minutes.
Clean the base with asoft cloth or
theincluded cleaning brush to
remove excess of mineral deposits.
Make sure all parts are dry before.
reassembling your humidifier

Cleaning the aroma pad tray
RECOMMENDED ONCE A WEEK
(0]
Push
~
Push to open the aroma pad tray at
the back of the base to pull it out.
Reassembling
0]
ress
)
Place the water filter backinto
the tank. Make sure the water
filter clicks in place.
Rinse with water and place back
into the base.
Place the fioat back into the base
chamber.
. Make sure the correct side of the fioat
is facing up.
b. Insert the longer prong into the fioat
brackets, and then place the shorter
prongnto the brackets.

[©] ®
»
%
Place the absorption pad and Place the mist tube on top of the
the noise silencer back to the hot/cold mist mixer. Make sure the
PTC heater. two parts clickin place.
® ®
l
&3
Place the mist tube and the Place the aroma pad back into the
hot/cold mist mixer over the aroma box.
base.