Dual Electronics Corporation XCAM100 Guide

XCAM100
What's Inside The Box
1. Product Sheet
2. XCAM100 Camera w/ Adjustable Mount
3. Power Cable w/ Fuse, Video Cable, 2 Mounting
Screws and Foam Rubber Mounting Pad
Mounting the camera
Look for a locaon that will give you the best view behind the vehicle.This should not be
directly next to or under a reverse/backup lamp as it may blind the camera at night.Avoid
license plate lamps as well as they may blind the camera at night. Before drilling,
determine the best way to run the power wires to the reverse lights & the extension cable
through the car.Insure that your route will not interfere with any safety equipment,trunk
release or other items in the vehicle.Look for wires, sensors,double metal,anything that
could cause a problem or damage.The camera should lay flat against the mounng surface
for proper installaon.
1.Use the included hardware to secure the camera to the vehicle.DO NOT OVERTIGHTEN the hardware.
2.Follow ONE of the following wiring opons.
Oprion 1: Connect camera power wire to the vehicle's reverse lamp:
a)Locate the reverse lamp in the tail light assembly.
b)Aach the red wire to the posive 12 volt wire from the reverse lamp.Use a crimp connector or soldering tool to ensure
connecon is secure. Once this connecon is complete,note that the red power wire that is located on either end of the video
RCA cable will not be needed. The bare wire at the end of each wire lead should be capped or taped off to prevent potenal
power interrupon.
c)Aach the black wire to ground(-).
d)Run video cable to the locaon of the receiver or monor(not included).Connect one yellow RCA end of the video cable to
the camera and connect the other end of the yellow RCA cable to the video source(receiver/monitor).
Opon 2: Connect camera power wire to receiver/monitor power:
a)From camera locaon,connect red power wire from power cable to red power wire from one end of the video cable.Use a
crimp connector or soldering tool to ensure connecon is secure.
b)Aach the black wire to ground.
c)Run video cable to the locaon of the receiver or monitor(not included).Connect not yellow RCA end of the video cable to the
camera and connect the other end of the yellow RCA cable to the video source(receiver/monitor).
d)From video source(receiver/monitor) locaon,connect red power wire from end of the video cable to the reverse wire lead
located on the video source(receiver/monitor).
Camera Specifications
Image Sensor: CMOS,7440H
Power: 12V DC,Negave Ground
Power Consumpon: ＜1 Wa
Effecve Pixels: 733H × 493V
Video Format: NTSC
Lux: ＜0.5
White Balance: Auto
Viewing Angle: 170 Degrees
IP Rang: IP67
Operang Temperature: -30℃ ~ +70℃
Camera Body: Zince Alloy

Limited One Year Warranty










   

   
    
  

  




  















What to do?
 

 


 





 
 



 



   
  









 






Dual Electronics Corporation
Heathrow, FL 32746
© 2020
Printed in China