Dura-Max Duragrain Privacy User manual
DURAGRAIN PRIVACY
www.duramaxbp.com
Have Questions?
Call us at 1-800-483-1361
Engineered For The Southwest SunTM
Gate Kit Assembly Instructions
Gate Lock and Hinges are not included
PLEASE READ THESE
INSTRUCTIONS
BEFORE ASSEMBLY
During assembly, vinyl components should be
laid on a non-abrasive surface (i.e. cardboard or
drop cloth) so as not to scratch.
• Use care when applying PVC cement, as it
dries quickly. Vinyl should be cleaned with
a mild detergent and non-abrasive cleaning
pad or sponge.
• Vinyl components should be assembled
without using excessive force, to avoid
breakage.
•
accurately locate hinge and latch post and
proper width size.
• Gates should not be made any wider than
48", to avoid sagging from hinge post.
• All hinge posts, properly installed, should
with concrete.
•
distance between hinge and latch post.
For Example: If the gate opening is 44"
TOOLS NEEDED
• Measuring Tape / Ruler
• Pencil
•
•
• Drop Cloth
• Square Level
• Rubber Mallet
USP © 2014
DURAGRAIN PRIVACY
GATE KIT ASSEMBLY INSTRUCTIONS
Step 2
Figure 2a
Mount the End Channel on top of the Upright Post,
Pocket Rail
End Channel
Upright Post
End Slot
Figure 2b
Fasthen the End Channel to the Upright
Post using (4x) Sheet Metal Screw as shown
Completed Upright Posts with the mounted End Channel. Figure 2c
Pocket Rail Metal Support
Step 1
(4 Pieces Included)
Figure 1
Metal Pocket
Rail Support
Pocket Rail
Sheet
Metal
Screw
DURAGRAIN PRIVACY
GATE KIT ASSEMBLY INSTRUCTIONS
USP © 2014
Step 3
Figure 3a Figure 3b
Picket
Picket
Upright Post
End Channel
3c. Then do the same procedure for the other side Upright Post (Figure 3d).
Figure 3c
Upright Post
Picket
End Channel
Pocket Rail Pocket Rail
Figure 3d
Use a Square Level for all the corners for proper leveling
and alignment before doing Step 4.
IMPORTANT
grooves and the last Upright Post (Figure 3e).
Figure 3e
End Channel
Pickets
Pocket Rail
End Channel
Picket
Upright Post
Pocket
Rail
Upright Post Upright Post
Pocket
Rail
USP © 2014
DURAGRAIN PRIVACY
GATE KIT ASSEMBLY INSTRUCTIONS
Step 4
(4 Pieces Included)
Uprights
Metal Support
Corner Lip Corner Lip
Insert one Uprights Post Metal Support
into one of the Uprights Post End Corner
(Figure 4a); make sure the corner lip of
the Uprights Post Metal Support is facing
towards the Pocket Rail.
Figure 4b
Step 5 Secure Uprights Post and the Pocket Rail with Sheet Metal Screws
Vinyl Screw Cap
Sheet Metal Screw
Figure 5b
Vinyl Screw Cap
Sheet Metal Screw
Put a small amount of Vinyl Glue on all
sides of the Post Cap and gently tap the
Post Cap into the top of the Uprights
with damp cloth (Figure 6). Repeat the
Post Caps.
Top
Uprights
Post
Figure 5d
Figure 6
Completed
DuraGrain Gate Kit
Post Cap
Vinyl Glue
Figure 5a Figure 5c
Insert
Figure 4a
Other Dura-Max Fencing & Gate manuals
